ENAR EBRO Serie Manual De Operación página 52

5.4 STARTING THE MACHINE
Procedure
en
Result
5.5 STOPPING THE MACHINE
Procedure
18 EBRO
EBRO 2C, EBRO 3C, EBRO 3D
Perform the procedure below to start the engine.
Turn the fuel cock to the "ON" (OPEN) position (a1).
1.
Note: If the engine is cold, move the choke lever to close position (b1). If the engine is
hot, set the choke to open position (b2).
Move the governor lever to left a little (c1). Turn the engine switch to "ON" position.
2.
(d1) Pull the starter rope (e).
Note: Don't allow the starter grip to snap back against the engine. Return it gently to
3.
prevent damage to the starter.
Preheat the engine and push back the choke lever to the "OPEN" position (f1).
4.
5. Move the throttle lever to the proper position to make the gasoline engine run at
required velocity.
The machine is now ready.
Perform the following procedure to stop the machine.
1. Push right the throttle lever to low speed position (c2).
Push the engine switch to the "OFF" position (d2).
2.
Set the fuel cock to "OFF" position (a2).
3.
WATER PUMP