Publicidad
Idiomas disponibles
Idiomas disponibles
6.2 SERVICING THE SPARK PLUG
Procedure
en
Result
22
EBRO
EBRO 2C, EBRO 3C, EBRO 3D
In order to ensure the engine normal running, gap of the spark plug must be correct and no
deposit around the spark plug.
WARNING
The muffler becomes very hot during operation and remains hot for a while after
stopping the engine. Do not touch the muffler while it is hot.
Note: Refer to section "Technical Data" for the recommended spark plug type and the
electrode gap setting.
Perform the procedure below to service the spark plug.
1.
Remove the spark plug cap (a).
2.
Clear away dirt around the spark plug base.
3.
Dismantle the spark plug with a spark plug wrench (b).
4.
Visually check the spark plug. Clean with a steel brush. If the insulator is
damaged, replace the spark plug instead.
5.
Measure the spark plug clearance with a feeler. The clearance should be 0.7 -
6.
0.8 mm (c). If adjustment is necessary, bend the side electrode carefully.
7.
Check if the spark plug gasket is in good conditions. In order to screw thread
misplace, screw in by hand.
8.
Screw on the spark plug to the bottom first by hand and then screw in by a spark
plug wrench and compress the gasket.
9.
If a new spark plug is used, more 1/2 turns after compressing the gasket. If
reinstalling the used spark plug, just more twist 1/8 - 1/4 turns.
NOTICE: A loose spark plug can become very hot and may cause engine damage.
The spark plug has now been cleaned and checked.
WATER PUMP
Publicidad
