cecotec THERMOSENSE 600 TOUCH BLACK Manual De Instrucciones página 19

ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Spout
2. Door opening button
3. Handle
4. Temperature indicator light
5. Power icon (on/off)
6. Temperature setting icon (Temperature setting: 40-55-80-90 °C)
NOTE
:
the graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This appliance is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the official Cecotec Technical Support Service
immediately.
Box content
- Electric kettle
- Instruction manual
- Before using the appliance for the first time, fill it up with clean water up to its maximum
capacity and bring to the boil. Empty the water from the kettle and repeat the process.
ATTENTION
: the maximum capacity of the kettle is 1.7 L, never exceed that capacity.
3. OPERATION
1. Place the appliance on a flat and dry surface.
2. To fill the kettle with water, remove it from the base and open the lid by pressing the
opening button. Fill the kettle with water to the desired level and then close the lid.
36
THERMOSENSE 600 TOUCH BLACK/WHITE
NOTE
:
Do not fill it below the minimum level (up to the "Min" indicator) to prevent the kettle from
running out of water during operation. Do not fill it with more than 1.7 litres of water (until the
"Max" indicator).
WARNING
! Do not fill the kettle above the maximum level, as water may spill out of the
spout while boiling. Make sure the lid is well placed before plugging the appliance into the
mains.
3. Place the kettle on the base.
4. Connect the appliance to a plug socket and turn it on by pressing the power icon.
5. As soon as the water boils, the kettle will switch off automatically. Once the kettle has
cooled down a little, you can boil the water again by pressing the power icon. While the
kettle is cooling down, it is recommended not to turn on the kettle forcibly, as this may
damage the operating mechanism.
6. Lift the kettle from the base and pour out the water.
WARNING
! Be very careful when pouring water from the kettle, as boiling water can cause
scalds. Do not open the lid when the water is boiling.
7. The kettle will not restart until you press the power icon again. You can leave the kettle on
the base when not in use.
WARNING
! Remember to always unplug the appliance if you are not going to use it.
8. Choose one of the following functions:
Function 1: press the power icon: the kettle will heat the water up to 100 ºC.
Function 2: after pressing the power icon, press the temperature setting icon to select the
desired temperature (40-55-80-90 °C). Water can reach a temperature of 100 ºC and remain
at that temperature for up to 24 hours.
Function 3: press the temperature setting icon to select the desired temperature (40-55-80-
90 ºC). This function allows water to be kept at the desired temperature for 24 hours.
Make sure you use purified water if you are going to use function 3.
Once the process is complete, the kettle will beep once.
If you want the kettle to stop heating, press the power icon.
Dry boiling protection
If you accidentally let the kettle run without water, the dry boiling protection will automatically
switch off the appliance. If this happens, allow the kettle to cool down before filling it with cold
water for reuse.
ENGLISH
THERMOSENSE 600 TOUCH BLACK/WHITE
37