Pause Function - Franke FHFB 905 5I ST Manual De Instrucciones

Switching hotplates off
Switching the hob off
Locking the control unit

Pause function

• Set the power level 1-9 by touching the slider (F). At the first touch, the level is set
according to the part of the slider that you touch. Upon the slider, the control LEDs
light up, according to the level set. By sliding along the slider, the power level setting
is changed. By sliding to the right, the level increasing, while sliding to the left
decreases the level. When you move your finger away from the slider, the cooking
field starts to operate at the level set.
If a specific point of slide control is pressed for at least 3 seconds, the automatic
cooking is activated (see Automatic fast heating).
Changing hotplate power settings
• By touching or sliding along the slide sensor (F) you change power setting.
• When you remove the finger from the slide sensor, the hotplate starts to operate at
selected power.
• Selected hotplate must be activated.
• By touching the slide sensor (F) at the start, bring the power setting to "0". Short
beep confirms the OFF position.
• The hob is switched off by pressing the main (A) sensor.
• The sound signal beeps and all indicators go off, except for those hotplates which
are still hot and display the warning "H" sign as an indication of the remaining heat.
• If you switch the hob off prior end of cooking session, use the remaining heat and
save electric energy.
By activating the key lock protection you can stop the operation of the appliance and
the use of hotplates.
Activating the control unit lock
• The cooktop must be turned on.
• Press the sensor (C) for approximately 1 second, the corresponding LED turns on
above the key, the block is active.
• Safety lock prevents the activation of al sensors, except for (A) and (C) sensor.
• If the hob is switched off when the lock function is activated, it remains in memory
until a new switches the hob.
• When set timers end their time, alarms can be switched by activating (D) or (E) keys
without need for unlocking the control.
Deactivating the control unit lock
• The cooktop must be turned on
• Press the sensor (C) for 1 second; after that, the unlocking is confirmed by a beep.
The execution of the function is only possible if at least one zone is on.
The pause condition may also be activated with cooking zone specific errors,
here, the error display is hidden. Also residual heat indication, special messages
such as A, P or no pan are hidden; the pause display has priority. If there is a
general error during the pause, the control switches off and terminates the mode.
Activating the Pause function
• Press the sensor (C) for at least 1 second, the corresponding LED turns on above
the key and all displays show the symbol "II".
While the Pause function is active:
• Any Timer (also Egg-timer) set before the pause will be stopped during the pause
and continue when pause mode is quitted.
• A selected booster or heat up time automatic function is terminated.
• Residual heat calculation and maximum operation time limitations will not be
interrupted and keep on working in the background.
25