Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installation procedure
CONNECTION TO THE POWER SUPPLY
Basic adjustment of
sensors to the ambience
Installation diagram
▪ Then, attach the gasket to the lower side of the glass, approximately 2-3 millimetres
from the edge.
▪ The gasket must be attached along the entire length of the glass edge and should
not overlap at the corners.
▪ When installing the gasket, make sure that the glass does not come into contact with
any sharp objects.
• Worktop must be placed absolutely horizontal.
• Suitably protect the edges of the cut aperture.
• Connect the cooking hob to the mains power supply (see instructions for the
connection of the cooking hob to mains power supply).
• Put the supplied springs in their places.
• Insert the hob into the cut aperture.
• Press the hob firmly towards the worktop from above.
• Connections may be carried out by a qualifi ed technician only. The earthing
protection must comply with the standing regulations.
• Connection terminals are revealed when the connection box cover is removed.
• Prior any attempted connection check that the voltage indicated on the rating plate is
in line with your home power supply.
• The rating plate is located underneath the appliance.
• The appliance is manufactured for use with the power supply voltage 220-240 V ~.
• In order to make a fixed connection to the mains, insert an all-pole circuit breaker
between the appliance and the mains. This device shall have a contact separation in
all poles, providing full disconnection under overvoltage category III conditions.
• Such appliances are allowed to be mounted on one side next to a high kitchen
cabinet, the height of which may exceed that of the appliance. On the opposite side
however, only a kitchen cabinet of equal height as the appliance is allowed.
• Upon the completion of installation, live wires and isolated cables must be
adequately protected against accidental touching.
Upon each connection to the power supply the sensors of the appliance are
automatically adjusted to the environment to ensure their proper function. All displays
turn on and are fully illuminated for a few seconds.
During the adjustment procedure the sensors must be free of any objects, otherwise the
adjustment procedure will be interrupted until such objects are removed from the
sensor surface. During this period the regulation of the cooktop is impossible.
ATTENTION !
Before attempting any repairs on the appliance, disconnect the power supply. In
accordance with the mains voltage the appliance should be connected in line with the
attached diagram.
The earthing wire (PE) must be connected to the terminal marked with the earthing
symbol.
The connection cable must lead through the relief safety device, protecting it from
accidental pulling out. Upon the completion of installation switch all the hotplates on for
about 3 minutes to check the proper functioning.
Connection may be carried out by means of:
- cables, model H05RR-F with yellow-green earthing cable;
- cables, model H07RN-F with yellow-green earthing cable.
21
Publicidad
Tabla de contenido
