Publicidad
Idiomas disponibles
Idiomas disponibles
Service
7
ReplacingBelt
2.
Remove the belt cover by removing
five hex screws. See
Fig. 7-1.
Remove the belt by grasping
it from the bottom
of the
auger pulley and pulling
outward.
NOTE: Push down on the idler puller to release the belt
from under the belt keeper. See Fig. 7-1.
To replace the belt follow these instructions
and refer to Fig. 7-2:
1.
Push down on the Idler pulley.
2.
Position the belt on top of the auger pulley, under the belt
keeper.
3.
Route the belt around the engine
pulley.
4.
Push the belt over the bottom
of the auger pulley.
5.
Reinstall the belt cover removed
earlier.
F
Auger Pulley
\
Figure 7-2
J
Publicidad
