Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly & Set-Up
3
Contents of Carton
Two Ignition Keys
One Snow Thrower
Operator's
Manual
One 2.6 oz. Bottle of Two Cycle Oil
One Tecumseh
Engine Operator's
Manual
One Extension
Cord (if equipped)
One Product
Registration
Card
NOTE:This
Operator's
Manual covers several models.
Snow
thrower
features
may vary by model. Not all features
in this
manual are applicable
to all snow thrower
models.
Assembly
Positioning the Upper Handle
1.
Making
sure not to pinch the cable in the process, pivot the
upper handle into the operating
position
as illustrated
in
Fig. 3-1 until it clicks into place.
J
Figure 3-1
2.
Tighten
the wing
knobs to secure the handle in place.
See Fig. 3-1.
Assembling the Discharge Chute
For shipping
reasons, the snow thrower
has been packaged
with
the upper chute pivoted
all the way down. To pivot it upward,
proceed
as follows:
1.
Remove the wing knob, flat washer and carriage
bolt from
the lower chute. See Fig. 3-2.
fs
/
/
2.
Figure 3-2
Pivot the upper chute upward
over the lip on the lower
chute so that there is no gap between
the upper chute and
the lower chute.
3.
r
Secure with the hardware
just removed.
Refer to Fig. 3-3.
Chute Handle
\
Figure
3-3
Publicidad
