FuelAndOilMixture
Your snow thrower
is equipped
with a two-cycle
engine that
requires
a mixture
of gasoline
and two cycle oil at a ratio of 50:1.
Refer to the engine operator's
manual for detailed
instructions
regarding
the mixture
of oil and gasoline
for your snow thrower's
engine.
Fuel Fill-Up
WARNING!
Use extreme
care when handling
gasoline. Gasoline
is extremely
flammable
and the
vapors are explosive.
Never fuel the machine
indoors or while the engine
is hot or running.
Extinguish
cigarettes,
cigars, pipes and other
sources of ignition.
1.
Check fuel level and add if necessary. Follow related
instructions
in the separate engine
manual
packed with
your snow thrower.
NOTE:A plastic insert may have been placed into the fuel tank to
prevent
dirt and debris from entering
the tank during
assembly.
Remove this insert before attempting
to fill with fuel.
Adjustments
ChuteAssembly
The pitch of the chute assembly
controls
the angle at which the
snow is thrown.
1.
Loosen the wing knob found
on the left side of the chute
assembly
and pivot the upper chute upward
or downward
to the desired
pitch. Retighten
the wing knob before
operating
the snow thrower.
2.
Position the chute assembly
opening
by using the Chute
Handle to throw the snow in the desired direction.
See Fig.
3-4.
!
Figure 3-4
SECTION 3 -- ASSEMBLY & SET-UP
7