Publicidad
Idiomas disponibles
Idiomas disponibles
Switch on the power supply using the power switch.
Switch the RUN/STOP switch to the "RUN" position.
Turn the directional switch (4) up so that the piston moves upwards.
Tilt the cylinder and place the meat inside.
Place the cylinder back on the frame.
Turn the directional switch (4) down and press the foot switch so that the piston starts to lower.
If the piston is lowering too fast or too slow, use the speed control knob to set the correct speed.
Remove the foot from the foot switch while filling the casing and the piston will stop.
When the piston moves down to the bottom of the cylinder, the unit will stop automatically. To raise the
piston upwards, turn the directional switch (4) upwards.
3.4.
Cleaning and maintenance
a)
Unplug the mains plug and allow the device to cool completely before each cleaning, adjustment or
replacement of accessories, or if the device is not being used.
b)
Use only non-corrosive cleaners to clean the surface.
c)
Use only mild, food-safe detergents to wash the device.
d)
After cleaning the device, all parts should be dried completely before using it again.
e)
Store the unit in a dry, cool place, free from moisture and direct exposure to sunlight.
f)
Do not spray the device with a water jet or submerge it in water.
g)
Do not allow water to get inside the device through vents in the housing of the device.
h)
Clean the vents with a brush and compressed air.
i)
Do not leave the battery in the device if it will not be used for a longer period of time.
j)
Use a soft, damp cloth for cleaning.
k)
Do not use sharp and/or metal objects for cleaning (e.g. a wire brush or a metal spatula) because they
may damage the surface material of the appliance.
l)
Do not clean the device with an acidic substance, agents of medical purposes, thinners, fuel, oils or
other chemical substances because it may damage the device.
DISPOSING OF USED DEVICES:
Do not dispose of this device in municipal waste systems. Hand it over to an electric and electrical device
recycling and collection point. Check the symbol on the product, instruction manual and packaging. The
plastics used to construct the device can be recycled in accordance with their markings. By choosing to
recycle you are making a significant contribution to the protection of our environment.
Contact local authorities for information on your local recycling facility.
EN
Publicidad
