Publicidad
Idiomas disponibles
Idiomas disponibles
To reduce the chance of FLASHBACK
FIRE you must
clean the Burner Tubes as follows at least once a month
in summer and fall or whenever spiders are active in your
area, and if your grill has not been used for an extended
period of time.
1. Turn all Burner Valves to the full OFF position.
2. Turn the LP Gas tank valve to the full OFF position.
3. Detach the LP Gas regulator assembly from your
gas grill.
,
,
,
Remove the Cooking Grids and Heat Diffuser from
your grill.
Remove the screws from the rear of each Main
Burner using a Phillips Head Screwdriver.
Remove screws along all sides of the Infra-red
Burner using a Phillips Head Screwdriver.
Carefully lift each Burner up and away from
the Gas Valve Orifice.
Regardless of which Burner cleaning procedure
you
use, we recommend
you also complete the following
steps to help prolong Burner life.
1. After each use of the main grill or infrared cooking
zone it is necessary to burn off food particles and
drippings which can clog Burner ports and reduce
Burner performance.
OPEN the grill Lid, ignite the
burner(s) and operate grill on Hi setting for
3 to 5 minutes. You can close the Lid if only main
Burners are lit, but NEVER close the Lid over a lit
Infrared Burner.
2. Use a nylon brush, blower or vacuum to remove
accumulated
ash from the outer surface of each
Burner. Clogged tube style Burner ports can be
cleaned with a stiff wire, such as an open paper clip.
DO NOT use a stiff brush or sharp tool of any type on
the fragile infrared Burner.
3. Inspect each Burner for damage (cracks or
holes) and if such damage is found, order and
install a new Burner. After
installation, check
to ensure that the Gas Valve Orifices are
correctly placed inside the ends of the Burner
Tubes. Also check the position of your Spark
Electrode.
,
,
Check and clean burnedventuri tubes for
insects and insect nests. A clogged tube
can lead to a fire beneath the grill.
Refer to Figure 1 and perform one of these three
cleaning
methods:
[]
[]
[]
METHOD
1: Bend a stiff wire or wire coat
hanger
into a small hook
as shown
and
run the hook through
the Burner Tube and
inside the Burner several times to remove
debris.
METHOD
2: Use a bottle brush with a
flexible handle and run the brush through
the Burner Tube and inside the Burner
several times to remove
any debris.
METHOD
3: Use an air hose to force air
through
each Burner Tube. The forced
air
should
pass debris
or obstructions
through
the Burner and out the Ports.
Figure
1
TO CLEAN BURNER TUBE,
INSERT HOOK AS INDICATED BY THE ARROW
For safe operation
ensure
the Gas Valve
Assembly
Orifice is inside the Burner Tube
before using your grill. See figure.
If the Orifice
is not inside the Burner Tube,
lighting the
Burner
may cause
explosion
and/or fire result-
ing in serious bodily injury and/or property
damage.
Tube Burner
Gas Valve Assembly
Orifice
/
/
/
Infrared
Burner
/
/
/
/
/
/
H
\\\\\\\\\\\
Burner Tube
//
/
Burner Tube
Griddle Burner
r
Gas ValvejAssembly
//
E:_::__
\ O rifi ce
....... . /
Burner Port
Foot
/
/
/
_" Burner Tube
27
Publicidad
