Linea 2000 DOMO DO7118S Manual De Instrucciones página 35

5. After ironing, place the iron on the thermal insulation pads. Turn the temperature dial back to "MIN"
to switch off the appliance. The appliance will produce an audio signal, the temperature indicator
light will start to flash. Press the on/off button again to turn off the appliance. Pull the plug out of the
power socket. Allow the appliance to cool down completely.
Caution: Never touch the hot soleplate!
STEAM IRONING
Caution: do not plug in the appliance yet at this point.
1. Fill the water tank with water. Make sure that you do not exceed the
maximum level (1.5 L). Use only mains water or 50 % mains water
and 50 % de-mineralised water if you have hard water.
2. Replace the water reservoir in the appliance.
3. Place the iron on the thermal insulation cushions.
4. Insert the plug into the power socket and press the on/off button
Turn the temperature dial to the fabric you want to steam iron
(Wool-Silk, Cotton or Linen). Each time you move the temperature
dial, you will hear a signal. The temperature indicator light will start
to flash, to indicate that the appliance is heating up to the desired temperature.
Note: The temperature dial must be rotated to within the margins of the steam symbol, otherwise
water droplets will emerge from the soleplate during ironing.
5. The appliance will start to heat up. Once the temperature indicator light stays on, you are ready to
iron with steam.
6. To iron with steam, press the steam button on the inside of the iron's handle. A continuous flow of
steam will come out of the sole. When you release the button, you will iron dry, without steam.
You can also iron vertically to e.g. steam your curtains, clothes on a hanger, etc.
7. Use a steam boost to get rid of stubborn wrinkles. Press the steam button twice in rapid succession.
There is a 15-second wait in order to use the steam boost a 2nd time. Note: this requires the
temperature dial to be set to 'SHOT'.
Please note:
· Do not touch the hot sole of the iron!
· Never aim steam at people!
8. After ironing, place the iron on the thermal insulation pads. Turn the temperature dial back to
"MIN". The appliance will produce an audio signal and the temperature indicator light will start to
flash. Press the on/off button again to turn off the appliance. Pull the plug out of the socket. Allow
the appliance to cool down completely.
9. If you do not use the steam button or temperature dial for 10 minutes, you will hear an audio signal
and the indicator light will start to blink rapidly. The appliance is now in standby and will no longer
heat up. If you press a button or set the temperature dial, the iron will stay at the right temperature.
If you have not pressed a button after 20 minutes, the appliance will automatically switch off. This is
a safety feature in case you forget to turn off the iron.
LOCKING AND UNLOCKING THE IRON ON THE BASE
· Place the iron on the base with the tip of the soleplate under the lock. Slide the
lock button to the lock symbol to lock the iron onto the base. You can now easily
move the iron together with the base.
· To unlock the iron from the base, slide the lock button to the open lock symbol.
The lock button will come up. You can now take the iron off the base.
www.domo-elektro.be
35
DO7118S