5. Sit comfortably while holding the nebuliser in your hand, place the
mouthpiece to your mouth or use a nasal piece (if provided) or mask.
If you use the mask accessory, place it on your face as shown in the
figure (with or without the use of the elastic band).
6. Switch on the device by pressing the switch (A1) and inhale and ex-
hale deeply; after inhaling, it is recommended to hold your breath for
a moment so that the inhaled aerosol droplets can settle. Then exhale
slowly.
7. When the application is finished, switch off the device and disconnect
it from the mains.
ATTENTION: If, after the therapy session, an obvious deposit of moisture
forms inside the tube (B1), detach the tube from the nebuliser and dry
it with the ventilation of the compressor itself; this action prevents possible mould growth inside the
tube.
To facilitate the connection of the connection tube (B1) to the compressor unit, act on the end of it by
simultaneously rotating and inserting it, and for removal by rotating and extracting it.
HOW TO USE THE "RF8 DUAL SPEED" NEBULISER WITH SPEED SELECTOR
To speed up inhalation therapy, turn the speed selector (B2.2.3) clockwise.
To make the inhalation therapy more effective, turn the speed selector (B2.2.3)
anticlockwise, in this case you will achieve optimal drug administration while
minimising the dispersion of the drug in the surroundings.
SoftTouch masks
Soft
biocompatible
material
Dispersion
Limiter
Upon inhalation, the tab, which acts as
a Dispersion Limiter, bends inwards in
the mask.
SoftTouch masks have an outer edge made of soft, biocompatible ma-
terial that ensures an optimal fit on the face, and are also equipped with
theinnovative Dispersion Limiter. These characteristic features allow
for greater sedimentation of the drug in the patient, and again limit its
dispersion.
20
Upon exhalation, the tab, which acts as
a Dispersion Limiter, bends outwards
from the mask.
HY
Sw
Co
Us
Ne
Op
in t
Th
Sa
Be
pro
me
de
me
me
rin
A
al
Dis
Aft
tab
in
me
hy
Ex
-
-
-
-
me
wa
me
str
ste
A
al
At