Publicidad
Idiomas disponibles
Idiomas disponibles
2. After few seconds
the display and the Connectivity
indicator starts blinking slowly.
3. Continue to follow the instructions in
the app to complete the onboarding
process.
4. While the process is ongoing, the
display may temporarily show
After the successful onboarding, the
Connectivity indicator stops flashing and
becomes solid. Display shows the set
temperatures.
Disabling the appliance wireless
connection
You can temporarily disable the Wi-Fi
connection by pressing and holding the
Connectivity button for 3 seconds. The
Connectivity indicator switches off and
the appliance beeps once.
Once the Wi-Fi connection is disabled, to
automatically re-establish the connection
press and hold the Connectivity button
for 3 seconds.
After reset, the Connectivity
indicator may be off. Wait a
few seconds until it turns on.
Resetting the appliance wireless
connection
Before you reset the Wi-Fi configuration,
make sure that the Connectivity indicator
is visible on the display. It means that the
function is switched on. If the function is
switched off, the attempt to reset the
connection will turn the function on.
You can reset the Wi-Fi configuration by
pressing and holding the Connectivity
button for 10 seconds. The appliance will
beep to confirm the successful reset.
To re-establish the connection, repeat all
the steps described in section "Disabling
the appliance wireless connection"
section.
4.14 Setting mode
The Setting mode allows you to:
• Enable or disable the ECOMETER
indicator
• Enable or disable the button sounds
• Change the temperature units from °C
appears on
• Reset the appliance to factory settings
Activating the Setting mode
To activate the Setting mode:
1. Press and hold the ECO button for
.
2. Once the Setting mode is switched
To deactivate the Setting mode, press
and hold the ECO button for
approximately 3 seconds.
The Setting mode deactivates
automatically if you do not interact with
the control panel for 60 seconds.
Navigating the Setting mode
1. Activate the Setting mode (refer to
2. Tap the fridge temperature button (on
Display
ECOMETER indicator
In order to switch the ECOMETER on or
off:
1. Activate the Setting mode (refer to
2. Tap
to °F
approximately 3 seconds. When the
Setting mode is being activated, the
display shows a blinking
on, the display shows
"Activating the Setting mode").
The display shows
the left) to change the parameter.
Tap the freezer temperature button
(on the right) to change the
parameter value.
Default parame‐
ters
ECOMETER indica‐
tor
Button sounds
Temperature units
Factory settings
"Activating the Setting mode").
The display shows
repeatedly. The indicator will
show respectively
or
for the disabled ECOMETER
indicator.
ENGLISH
13
.
.
.
.
for the enabled
Publicidad
