Diamond 1100 Manual De Instrucciones página 34

OPeRATIng InSTRUCTIOnS
Start-up for cooking and loading/
unloading products
N.B.! Before proceeding with these operations, see
"Daily activation".
When lighting for the first time, wait for the pos-
sible formation of air inside the gas circuit to fully
escape from the duct.
•
Lighting open burners (Figure 1)
Turn the knob while holding it in the piezoelectric posi-
tion (Detail A).
Position a flame (lighter or something else) on the pilot
and wait for it to light up (figure 1).
Release the knob after about 20" and check to make
sure the pilot light remains lit.
When the pilot light has been lit, turn the knob (Detail B)
to minimum or maximum to adjust the flame.
•
Lighting gas oven (Figure 2)
Turn the knob while holding it in the piezoelectric posi-
tion (Detail C). Simultaneously press the piezoelectric
button several times (Detail D) until the pilot light is lit.
Release the knob after about 20" and check to make
sure the pilot light remains lit (figure 2).
N.B.! The pilot light can be seen through the hole
on the oven top.
When the pilot light has been lit, turn the thermostat
knob to the desired temperature (figure 2 Detail e).
•
Switching electric oven on (Figure 2A)
Turn the thermostat knob to the desired position (fig. 2A
Detail f). The indicator lights "g" and "H" indicate an
operating phase.
Green indicator light: The indicator is subordinated
to use of the switch-on knob. lighting of the indicator
signals the operating phase.
Yellow indicator light: The indicator is subordinated
to use of the thermostat knob. lighting of the indicator
signals the heating phase.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
A
1
Fig.
C
2
Fig.
E
2A
Fig.
- 11 - 11
B
D
E