Diamond 1100 Manual De Instrucciones página 40

ROUTIne MAInTenAnCe
Troubleshooting
N.B.! Whenever the appliance does not work properly, try to solve the less serious
problems using this table.
FAULT
The appliance does not turn on
Water does not reach the pasta
cooker tank
Water does not drain from the
cooking cavity
The inner walls of the tank are
covered with limestone
The cooking cavity is stained
The gas appliance does not turn
on
The light indicators do not turn
on
N.B.! If the problem cannot be resolved, turn the appliance off and shut all the sup-
ply valves. Then contact customer service.
THE PRESENT MANUAL IS PROPERT Y OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
PoSSIBLE CAUSE
•
The master switch is not
connected
•
The residual current device
or circuit breaker has tripped
•
The waterworks gate valve
is shut
•
The drain is clogged
The water is too hard; the sof-
tener is finished
•
Quality of the water
•
Ineffective detergent
•
Insufficient rinsing
•
gas valve shut
•
Air inside pipes
•
The master switch is not
connected
•
The residual current device
or circuit breaker has tripped
- 17 - 17
INTERVENTIoN
•
Connect the master switch
•
Switch the residual current
device and/or circuit breaker
back on
•
Open the waterworks gate
valve
•
Clean the drain filter
•
free the drain from residues
•
Connect the appliance to a
water softener
•
Regenerate the water sof-
tener
•
Descale the cooking cavity
•
filter the water (see water
softener)
•
Use the recommended
detergent
•
Rinse once again
•
Open the gas valve
•
Repeat the ignition opera-
tions
•
Connect the master switch
•
Switch the residual current
device and/or circuit breaker
back on