Publicidad
Idiomas disponibles
Idiomas disponibles
4.3 Noise
Noise emitted by the 650 ET and 850 ET: < 70 dB
Noise emitted by the 650 STH and 850 STH: 84.1 dB
4.4 Vibrations
The vibrations produced are minimal and do not represent a source of
danger for the operator. The levels have, however, been determined in
accordance with ISO 5349.
No particular procedures must be adopted in order to safeguard
the operator from the effects of the vibrations produced. In the
event of abnormal vibrations, the operator should immediately
stop the machine and contact maintenance personnel.
4.5 Degree of protection of electric machines (IP)
Degree of protection against solid objects (protected
against dust)
Degree of protection against water (protected against
splashes of water)
4.6 Admissible environmental values
Admissible environmental values
Admissible
operating
temperatures
Variations
in
ambient
temperature
Relative humidity range
Vibrations
The machine may also be operated out of doors providing the surface
is asphalted, concreted or similar and dry. The machine is not suitable
for operating in environments at risk from fire or explosion.
The machine may not be used in areas with an
explosive
atmosphere
components or equipment designed to operate in
explosive atmospheres must be indicated with the
(ATEX) mark in accordance with EN 60079-14
Use of machines with internal combustion engine in
closed or poorly ventilated environments (e.g.
greenhouses, warehouses, workshops, stalls, vertical
covered silos, etc) and the resulting combustion
fumes given off from the exhaust represent a risk of
intoxication and may cause injury or death.
The machine may not be used in areas where an IP
protection level of more than 33 is required.
4.7 Guards
All dangerous areas are closed with guards and protective devices
fixed to the chassis with screws making all hazardous areas
inaccessible to the operator. There is one removable guard, the hinged
door on the cowling to access the engine for starting or filling with fuel.
This opening has been designed in such a way as to prevent access to
dangerous parts.
4.8 Safety devices
The machine is not fitted with an independent lighting system.
5 Transport and installation
5.1 Lifting and handling
IMPORTANT - Follow the instructions below.
The machine is delivered from the Manufacturer on a pallet and
packed in a special cardboard box. Before unpacking, the machine
can be transported and handled by means of a lift truck with a capacity
of at least 250 kg.
3
3
-10° C - 50° C
(50° F - 113° F)
Max. 1.1° C / Min (Max 2° F /
Min)
75% or less
≤ 0.5 G
Machines
and
relative
1.
2.
3.
Straps
Crate
To unpack the machine, remove the straps holding the cardboard box
to the pallet and remove the box. After the machine has been
unpacked, it must be lifted by passing lifting straps through the two
rear hooks. A number of safety instructions relating to transport are
given below.
5.2 Installation
IMPORTANT - Before proceeding with installation
read the following warnings carefully.
Failure to observe the following warnings could
cause injury, death or damage to equipment.
Models with internal combustion engine 650 STH and 850 STH are
delivered with the side brush dismounted for packing reasons. Before
use, the side brush must be attached and the machine filled with fuel.
Block the side brush support at an angle by pressing the
•
pedal on the right.
Bottom brush
raising pedal
Remove the debris collection bin;
•
Tilt the machine, using a support (not provided) positioned
•
under the front of the machine;
Support
Fix the brush to the pulley by tightening the three screws.
•
GB
Pallet
Top release pedal
Publicidad
