ABB ACH580-34 Guía Rápida De Instalación Y Puesta En Marcha página 3

EN – Quick installation and start-up
guide
This guide tells you briefly how to install the drive module into a 800 mm wide Rittal
VX25 enclosure and start-up the drive.
Obey the safety instructions
General safety
￭
These instructions are for all personnel who do work on the drive.
Obey the safety instructions of the drive. If you ignore them, injury or
death, or damage to the equipment can occur.
• Keep the drive in its package until you install it. After unpacking, protect the drive
from dust, debris and moisture.
• Use the required personal protective equipment: safety shoes with metal toe cap,
safety glasses, protective gloves and long sleeves, etc. Some parts have sharp
edges.
• When the drive or connected equipment is energized, do not do work on the drive,
motor cable, motor, control cables or control circuits.
• Do not do work on the drive when a rotating permanent magnet motor is
connected to it. A rotating permanent magnet motor energizes the drive, including
its input and output power terminals.
• Do not use the module extraction/installation ramp with plinth heights that exceed
the maximum allowed height.
• Attach the module extraction/installation ramp carefully.
• Make sure that the module does not topple over when you move it on the floor:
To open the support legs, press each leg a little down and turn it aside (1, 2).
Whenever possible attach the module also with chains. Do not tilt the drive module.
It is heavy and its center of gravity is high. The module overturns when tilted more
than 5 degrees. Do not leave the module unattended on a sloping floor.
EN – Quick installation and start-up guide 3
EN
DE
ES
FR
IT
TR