Descargar Imprimir esta página

YATO YT-82110 Manual Original página 13

Publicidad

PROPERTIES OF THE ANGULAR GRINDER
The angular grinder is an electric tool designed for grinding and cutting metals as well as mineral construction materials, such as
bricks, natural and artifi cial stone, concrete, glaze, etc. with abrasive disks and grinding wheels selected for the given material.
The tool must not be used for processing other materials than those mentioned above, e.g. for grinding and cutting wood. A cor-
rect, reliable and safe functioning of the grinder depends on its proper use, so:
Before you proceed to operate the grinder, read the manual thoroughly and keep it.
Always use protective goggles!
Do not use grinding wheels whose maximum acceptable tangential velocity is lower than 80 m/s!
Do not use grinding wheels whose maximum acceptable rotational speed is lower than the rotational speed of the
grinder.
The supplier will not be held responsible for any damage resulting from the safety regulations and the recommendations indicated
hereby not being observed.
EQUIPMENT OF THE ANGULAR GRINDER
Grinders are supplied with the following elements:
- additional handle
- guard of the grinding disk
- key for fasten the grinding disk
Abrasive disks are not included.
TECHNICAL PARAMETERS
Parameter
Catalogue no.
Mains voltage
Mains frequency
Nominal power
Nominal rotation
Diameter of the grinding disk
Diameter of the hole of the grinding disk
Spindle end
Mass
Level of noise
- acoustic pressure L
± K
pA
pA
- power L
± K
wA
wA
Level of vibrations
± K
ah,AG
Insulation class
Protection grade
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any
plug adapters with earthed power tools. An unmodifi ed plug that fi ts the outlet reduces the risk of electric shock.
Avoid contact with earthed surfaces such as pipes, radiators and coolers. Grounding the body increases the risk of electric shock.
Do not expose power tools to contact with atmospheric precipitation or moisture. Water and moisture that gets inside the
O R I G I N A L
GB
Unit of measurement
[V~]
[Hz]
[W]
[min
]
-1
[mm]
[mm]
[kg]
[dB (A)]
[dB (A)]
[m/s
]
2
I N S T R U C T I O N S
Value
YT-82110
230
50
2800
6600
230
22
M14
6,6
91,8 ± 3,0
102,8 ± 3,0
4,478 ± 1,5 / 4,956 ± 1,5
II
IPX0
13

Publicidad

loading