Publicidad
Idiomas disponibles
Idiomas disponibles
- 2s later, while the display screen is flashing, set the alarm time using
buttons (12) and (13).
The default setting is 45min (the display shows "
To save the settings press any button or wait 5s for the system to
automatically save the time.
- During the countdown, any operation on the control panel resets the
counter and counts down again.
When the countdown is complete, the display will show: "
unit will beep for about 10s.
- When the beep stops, press any button on the display to restart the
countdown.
If no action is performed after 10s from the start of the beep, the unit will
beep again after 5 minutes.
Further inactivity after the second beep will disable the desk
- To switch off the alarm function press button A (18) for approx. 3s.
The display will show "OFF" or "oFF".
5. Collision avoidance settings
A function to avoid collision and damage to the desk. If the desk encounters
resistance during height adjustment, the motors will stop and reverse the
desk position.
-Press keys (12) and (13) simultaneously for approx. 5s to enter the sensitivity
setting.
Each input changes the level by 1 degree, the display indicates the set level.
- Levels description: A0 - function off, A1- low sensitivity, A2- medium
sensitivity, A3 - highest sensitivity (factory setting).
6. Resetting the unit
To enter the reset mode press and hold the 3 (16) and M (17) buttons, the
display will show "
Then press and hold the down button (13) until the desk reaches its lowest
position and stops and the display shows the height indication.
Then release the button. The reset is now complete.
If the desk still displays error messages or the height indication is wrong,
please contact the manufacturer's service department.
3.4.
Cleaning and maintenance
a)
Pull out the mains plug before each cleaning and when the unit is not in use.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
" or "
".
").
", and the
Publicidad
