Descargar Imprimir esta página

BH FITNESS G120TT Instrucciones De Montaje Y Utilización página 15

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Finally place the top cap for the
weights (7), Fig.2, fit screws (9)
along with the washers (10) and nuts
(8) and tighten securely.
Place the bracket (18) on the bars
(3) as shown in Fig.3.
Place the main body (14), Fig.10,
onto the main body (5), inserting it
onto the frame (1), Fig.3.
Attach the main body (14), using
screws (15) along with the washers
(16) and tighten securely.
Now fit screws (19) along with the
washers (4) and nuts (20) and
tighten securely.
By other side place the screws (5)
along with the washers (4) and
tighten securely as shown in fig 3.
Next, position left tube (21) and
secure it to main body (14) along the
plate (25) and lateral pulley (23),
Fig.4, using screws (24) along with
the washers (16) and the nuts (17)
and tighten.
By other way place the screw (15)
along with the washer (16) and
tighten as shown in Fig 4 the tube
(21) together with the frame(1).
Now go through the same procedure
for the right side.
NOTE: Once this stage of the
assembly has been completed, all of
the bolts fitted previously should be
retightened securely.
Fit the butterfly arm support (29)
onto the main body (14), Fig.5.
Insert
screws
washers (16) and tighten securely.
Place the lateral support (28) and
secure it using screws (32) along
with the washers (16) to the main
body (14) and tighten securely as
shown in fig 5.
(32),
along
with
Place the butterfly arms (26) and
(27) in the support shafts (29) fig 5.
Place the knobs (33) onto the shafts
for the support (29), secure using
the caps (31) along with the washers
(30).
Insert the seat support (35) onto the
post sticking out of the tube (34)
Fig.6.
Line up one of the height setting
holes, Fig.6, on the seat support and
release the knob then tighten the
knob (33) by turning it clockwise.
Position the backrest support (35) on
the main body (14), Fig.6. Insert
screw (24), along with washers (16)
and
locknut
securely.
Take the leg support (36), fit the
spacer (38) on the inside of the
bushing for the leg support (36),
Fig.6.
Fit it into the holes on the seat
support (35) by lining up the holes
insert screws (5) along with the
washers (39) and (4) and secure
them.
First insert the caps (41) in the top
leg tube. Place the bottoms foams
(40) of the leg support (36).
Finally, fit the caps (42) onto the
ends of the foam covers (40), Fig.6
along with the screws (43).
Place the footrest (37) on the
support tube (34) fig 6. Introduce the
screw (19) along the washers (4)
and tighten with the nut (20).
Screw the tip of the cable (53) onto
the weight guide (2), Fig.7, then take
the other end of the cable (53) and
pass it through the top pulleys and
the middle pulley (46) as shown in
Fig.7.
15
(17),
and
tighten

Publicidad

loading