Publicidad
Idiomas disponibles
Idiomas disponibles
4. INITIAL CONFIGURATION
EN
PROGRAM
Mo Tu We Th Fr Sa Su
Edit
Copy
PROGRAMACIÓN
Mo Tu We Th Fr Sa Su
17:00
18:00
OK
If Copy is selected, navigate through the days in which you want to copy the current day with
the +/- keys and select with MODE. Confirm with the CONF button.
In the 1700w, 2550w and 3400w models, by default the programming is configured from
Monday to Sunday as follows: From 00:00 to 07:00: OFF mode / From 07:00 to 17:00: Eco
mode / From 17:00 to 23:00: Comfort mode / From 23:00 to 00:00: Eco mode.
In the 1630w, 2450w and 3260w models, by default the programming is configured from
Monday to Sunday as follows: From 00:00 to 08:00: OFF mode / From 08:00 to 17:00: Eco
mode / From 17:00 to 23:00: Comfort mode / From 23:00 to 00:00: Eco mode
Advanced
ADVANCED
DEVICE TYPE
FROST PROT.
PROG. RESOL.
CHARGE CONF.
7ºC. Default value: Activated.
Program resolution: In this parameter you can define if the programming is carried out every
"one hour" or every "half hour". Default value: One hour.
Charge configuration: In this section you can adjust the values referring to the load and the
support resistance.
Support resistor configuration: If ONLY PEAK is selected, the support resistor can be
•
turned on outside the load period if the fan is not enough and the load is low (- 50%). The
28
ECOJOULE
Programming: If the operating mode is FIXED
TEMPERATURE (see page 27), this option will be disabled.
In this section you can configure the weekly programming by
choosing one of the modes for each hour (off, comfort, eco
or antifreeze).
Select the day you want to modify with the +/- keys and
confirm with MODE. Choose between editing or copying with
the +/- keys and confirm with MODE.
If Edit is chosen, scroll through the hours with +/- and
change the mode with the MODE key. When the temperature
is defined in one hour, advance with +/- until the next hour
that you want to set and repeat the process. Confirm the
changes with the CONF button. (If you want to modify
another day of the week, press CONF again and scroll with
+/- through the days)
Device type: You can choose between fixed temperature
(the storage will maintain the same temperature throughout
the day) or weekly programming (the storage will maintain
the temperature selected by the user in the Programming
section). Default value: Programming
Frost protection: If this parameter is activated, the support
resistance will come into operation, even if the storage is in
Standby mode, when the ambient temperature is lower than
Publicidad
