Publicidad
Idiomas disponibles
Idiomas disponibles
User guide Junior whisks / Master whisks
Clean the stand in clean water using
EN
washing up liquid if necessary.
Be carreful : risk of cuts when
cleaning the mixer with the whisk
tools.
NEVER clean the appliance using a hose.
NEVER immerse the motor block in liquid.
MAINTENANCE
It is preferable to regularly check:
- That the power cable is in good condi-
tion (the copper wires in the cable
should not be visible).
- That the appliance is watertight
- That the whisk tools are sharp.
If the power cable is damaged, it must be
replaced by the manufacturer, its after-
selfs service or people of similar qualifica-
tion to avoid danger.
ELECTRIC REQUIREMENTS
The mixer of a class 2 category (double
insulation) powered by a single phase
alternating current and does not require a
"u" ground plug.
The installation must be protected by a
ground fault circuit breaker and a 10 A
calibre fuse.
Use a standard 10/16 A single phased
socket.
Check that the electricity supply voltage
and the value on the mixer specifications
plate are compatible.
10
ELECTRICAL DIAGRAM
S1
N
L
CERTIFICATE OF CONFORMITY
CUSTOMER SERVICE AND
WARRANTY
This machine is in accordance with CE
standards and :
• Customer service and warranty:
Should your unit require service, contact
your distributor for the nearest authorized
service centre if you wish your unit to be
serviced by the manufacture ship it to :
CANADA SERVICE CENTRE DYNAMIC
INTERNATIONAL LTD.
3227 boul. Pitfield
Saint-Laurent - Québec H4S-1H3
Toll free phone : 1-800-267-7794
Toll free fax : 1-877- 668-6623
Local Phone : (514) 956 0127
Local Fax : (514) 956 8983
USA SERVICE CENTRE DYNAMIC USA
1320 route 9 # 1352 - Champlain,
NY - 12919
Toll free phone : 1-800-267-7794
0.1 uf
Variator
Motor
Moteur
Publicidad
