Preparing To Use The Unit; Features; Charging The Internal Battery Of The Jump Starter - Schumacher SL1397 Manual Del Usuario

2.12 This product contains a lithium ion
battery. In case of fire, you may use
water, a foam extinguisher, Halon,
CO , ABC dry chemical, powdered
2
graphite, copper powder or soda (sodium
carbonate) to extinguish the fire. Once
the fire is extinguished, douse the

3. PREPARING TO USE THE UNIT

WARNING! RISK OF CONTACT WITH
BATTERY ACID. BATTERY ACID IS A
HIGHLY CORROSIVE SULFURIC ACID.
3.1 Make sure the area around the battery is
well ventilated while the unit is in use.
3.2 Clean the battery terminals before using
the jump starter. During cleaning, keep
airborne corrosion from coming into
contact with your eyes, nose and mouth.

4. FEATURES

1

5. CHARGING THE INTERNAL BATTERY OF THE JUMP STARTER

IMPORTANT! CHARGE IMMEDIATELY
AFTER PURCHASE, AFTER EACH USE
AND EVERY 30 DAYS, TO KEEP THE
JUMP STARTER'S INTERNAL BATTERY
FULLY CHARGED AND PROLONG
BATTERY LIFE.
CHECKING THE LEVEL
OF THE INTERNAL BATTERY
Press the ON/OFF Power switch. The
Battery Status LEDs will light for 30 seconds
and then turn off. While the Battery Status
LEDs are off and the ON/OFF Power switch
is on, press the Battery Status/Light
button on the front of the unit. The LEDs will
indicate the current charge level as follows:
RED – less than 20% of full charge;
immediately charge the unit.
YELLOW – 20-80% of full charge.
GREEN – more than 80% of full
charge.
3 4 5
2
product with water, an aqueous-based
extinguishing agent, or other nonalcoholic
liquids to cool the product and prevent the
battery from re-igniting. NEVER attempt
to pick up or move a hot, smoking, or
burning product, as you may be injured.
Use baking soda and water to neutralize
the battery acid and help eliminate
airborne corrosion. Do not touch your
eyes, nose or mouth.
3.3 Determine the voltage of the battery by
referring to the vehicle owner's manual and
make sure that the output voltage is 12V.
3.4 Make sure that the unit's cable clamps
make tight connections.
6
1. Battery clamps
7
2. Micro-USB charging port
3. Ready/Fail LED
4. Battery status/Light button
8
5. Battery status indicators
6. Built-in work light
7. ON/OFF Power switch
8. USB port
CHARGING THE INTERNAL BATTERY
The jump starter will fully charge in 3-4 hours.
NOTE: Use a 2A USB charger (not
included), or a 2A USB charging port to
quickly recharge the jump starter. Using
a charger with less than 2A will increase
charge time.
1. Plug the Micro USB end of a charging
2. Plug your charger into a live power
3. When the unit is charging, the LEDs
Red LED flashing: 0-5% charged
Red LED solid: 6-19% charged
Yellow LED solid: 20-80% charged
Green LED solid: 81-100% charged
• 5 •
cable into the input port. Next, plug the
USB end of the charging cable into
your charger's USB port.
source.
above the Battery Status/Light
button will light to show the charging
percentage as follows: