Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
1
Determine the HeaderBracketLocation
To prevent possible SERIOUSINJURYor DEATH:
* Headerbracket MUST be rigidly fastened to structural
support on header wall or ceiling, otherwise garage door
might not reversewhen required. DO NOT install header
bracket over drywall.
• Concrete anchors must be used if mounting header bracket
or 2x4 into masonry.
• NEVERtry to loosen, move or adjust garage door, springs,
cables, pulleys, brackets, or their hardware, ALL of which are
under EXTREMEtension.
• ALWAYScall a trained door systems technician if garage
door binds, sticks, or is out of balance. An unbalanced
garage door might not reverse when required.
Installation procedures vary according to garage door types.
Follow the instructions which apply to your door.
1. Close the door and mark the inside vertical centerline of the
garage door.
2. Extend the line onto the header wall above the door.
You can fasten the header bracketwithin 4 feet (1.22 m) of
the left or right of the door center only if a torsionspring or
center bearing plate is in the way; or you can attach it to the
ceiling (see page 13) when clearance is minimal. (It may be
mountedon the wall upside down if necessary,to gain
approximately1/2" (1 cm).)
If you need to install the header bracket on a 2x4 (on wall or
ceiling), use lag screws (not provided) to securely fasten the
2x4 to structural supports as shown here and on page 13.
3. Open your door to the highest point of travel as shown. Draw
an intersecting horizontal line on the header wall above the
high point:
• 2" (5 cm) above the high point for sectional door and
one-piece door with track.
• 8" (20 cm) abovethe high point for one-piece door without
track.
This height will provide travel clearance for the top edge of the
door.
NOTE:If the total number of inches exceedsthe height
available in your garage, use the maximum height possible, or
refer to page 13 for ceiling installation.
Header Wall
Unfinished
Ceiling
Vertical Centerline
of Garage Door
OPTIONAL
CEILING
MOUNT
FOR
HEADER
BRACKET
2x4
Structural
Supports
Header Wall
_L-_2"
(5 cm)
Track
_ighest
Point
of Travel
-- Door
Sectional
door with curved track
Y
Header Wall
Track
I
_ighest
Point
_"
of Travel
r
One-piece
door with horizontal
track
Wall
Highest
Hardware
One-piece
door without track:
jamb hardware
Header Wall
One-piece
door without track:
pivot hardware
12
Publicidad
