Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
STEP
12
Fastenthe Door Bracket
Follow instructions which apply to your door type as illustrated
below or on the following page.
A horizontal reinforcementbrace shouldbe long enoughto be
securedto two vertical supports.A vertical reinforcementbrace
shouldcover the height of the top panel.
The illustrationshows one piece of angle iron as the horizontal
brace. For the vertical brace, two pieces of angle iron are used to
create a U-shaped support (Figure 1). The best solution is to
check with your garage door manufacturer for an opener
installation door reinforcement kit.
NOTE:Many vertical brace installations provide for direct
attachment of the clevis pin and door arm. In this case you will
not need the door bracket, proceed to Installation Step 13.
SECTIONAL DOORS
1. Center the door bracket on the previously marked vertical
centerline used for the header bracket installation. Note correct
UP placement, as stamped inside the bracket (Figure 2).
2. Position the bracket on the face of the door within the
following limits:
• The top edge of the bracket 2"-4" (5-10 cm) below the top
edge of the door.
• The top edge of the bracket directly below any structural
support across the top of the door.
Fiberglass, aluminum or lightweight steel garage doors will
require reinforcement BEFORE installation of door bracket.
Contact your door manufacturer for reinforcement kit.
HARDWARESHOWN ACTUALSIZE
@ @
Nut 5/16" 18
Lock Washer
5/16"
Carriage Bolt
5/16" 18x2 1/2"
• Mark and drill 5/16" left and right fastening holes. Secure
the bracket as shown in Figure 1 if there is vertical
reinforcement.
If your installation doesn't require vertical reinforcement but does
need top and bottom fastening holes for the door bracket, fasten
as shown in Figure 2.
Header Bracket
Horizontal
and vertical reinforcement
is needed for lightweight
garage doors
(fiberglass, aluminum,
steel, doors with
glass panel, etc.). (Not Provided)
Vertical
Reinforcement
Vertical
Door
Inside Edge
of Door or
einforcement
Board
/i! o
Carriage Bolt
5/16" 18x2 1/2"
Door
Bracket
__.
ock
Washer
5/16"
\
"@-@.
i
i
Nut
5/16" 18
Door Bracket
Figure2
UP
Figure I
23
Publicidad
