OSOTEK Horizon H200 Lite Manual De Usuario página 10

Self-Cleaning
• Place the vacuum cleaner on the charging dock properly, and press the
cleaning. After the self-cleaning is over, the vacuum cleaner will enter the charging status
automatically.
• Press the button or the button to stop the self-cleaning process.
Notes:
• Clean the dirty water tank in time after self-cleaning to prevent odors.
• It is recommended to regularly clean parts that cannot be cleaned by self-cleaning, such as the
roller brush cover and the parts around the suction port.
Care & Maintenance
button to start self-
CAUTIONS:
Clean and maintain the relevant components when the vacuum cleaner is paused in the upright
position or turned off.
Maintenance Frequency
Component
Dirty water tank components (including the dirty
water tank, solid waste bin, and full tank sensor)
Dirty water outlet pipeline
Water & Air Separator
Floor Brush (overall)
Roller Brush
Filter
Charging dock
Replacement Frequency
Note:
The following recommended replacement frequencies are for reference only. Components should
be replaced promptly if damaged.
Component
Roller Brush
Filter
9
Recommended Maintenance
Frequency
Clean after each use.
Clean when prompted by the
display show an error message.
1-3months.
Clean once a week, depending on
the dirtiness.
Self-cleaning is required after
each use.
Clean it monthly.
Clean once a week.
Recommended
Replacement Frequency.
3-6months.
6-12months.