Bimar VP42T Folleto De Instrucciones página 13

 The power socket must be easy to reach so the plug can be removed quickly in
case of emergency.
 To not place the appliance near sinks or other container of liquids (minimum
distance of 2 meters) to avoid the risk of it falling in.
 Do not place the appliance near an open flame, cooking or other heating
appliance.
 Keep the fan far away from fabrics (curtains, etc.) or unstable materials that
could obstruct the air intake grille; make sure that the front is free of unstable
materials (dust, etc.).
 Make sure that the electric cord is not touching rough, hot or moving surfaces
and not twisted or wrapped around the appliance.
 Stand the appliance on a horizontal, flat surface or table; do not stand on a
inclined plane (the appliance could upset).
ASSEMBLY
Before assembling the fan, make sure it is unplugged from the socket.
The appliance can only be used once correctly assembled in all its parts, complete
with counterweight base, protective grills, propeller.
Proceed as shown and use the images for reference.
A. Unscrew and remove the ring nut (6) from the column, insert the ring (3), and
tighten the ring nut again.
B. Set the column (14) in place on the base and secure it using the "L" screw with
washer (1) while also engaging the counterweight.
C. Make sure column and base and counterweight are firmly coupled.
D. Unscrew the ring nut (15) and the ring nut (16) (turn clockwise) from the motor
body.
E. Insert the rear grill (12) into the motor body, make sure the handle is at the top
and lock it using the ring nut (15).
F. Insert the propeller (13) onto the drive shaft (5) and lock it with the ring nut
(16) (turn counter clockwise and tighten).
G. To fasten the front grill, it is best to place the main unit on a smooth even floor.
Couple the front grill (11) to the rear (12) and hold in place with plastic ring, (a
fixing screw is good at the bottom) and secure fastening by tightening screw
(10).
H. At the end of the operation, check that the protective grills are firmly coupled
and attached to the motor.
13