Blackstone PRO Serie Manual Del Propietário página 16

Troubleshooting
Owner's Manual |
!
C A U T I O N
Place the included hard-
cover on the burner when
not in use or if it begins to
rain. Never leave oil exposed
in the rain. This can lead to
severe burns.
dle
!
C A U T I O N
r.)
Place the included hard-
cover on the burner when
not in use or if it begins to
rain. Never leave oil exposed
in the rain. This can lead to
severe burns.
Insert one (1) AA battery (not
included) into the battery socket
with the positive terminal facing
nega-
out, then screw on the ignitor
button until tight. Be careful to not
over tighten.
osi-
rner
e.
e-
3-7mm
n of
Ensure that the ignition needle is
positioned 3-7mm away from the
burner tube, positioned above a
burner hole.
12 blackstoneproducts.com/support
Assembly Guide
People can not sit or stand
on the side table.
S T E P 13
stalled M4 screws from the hard
cover handle to install the hard
cover handle to the front of the
hard cover.
S T E P 14
People can not sit or stand
on the side table.
Hange the hard cover in the slots on the back of the griddle body.
Place the cutting board on the right side shelf.
Insert one (1) AA battery (not included) under the ignition button.
!
C A U T I O N
Use the two (2) pre-in-
!
C A U T I O N
Place the range burner grate over the range burners.
!
C A U T I O N
Grease build-up on the
Flame Tamper can catch fire
when heated.
To prevent damage to the
unit and/or injury, clean the
top of the Flame Tamper
after each use.
!
C A U T I O N
Grease build-up on the
Flame Tamper can catch fire
when heated.
To prevent damage to the
unit and/or injury, clean the
top of the Flame Tamper
after each use.
Model 2008