If the refrigerator is installed in the moisture place, make sure to check whether the ground wire and leakage circuit
breaker are normal. If vibration noises are produced due to the refrigerator contacting the wall or if the wall gets blackened
by air convection around the compressor, move the refrigerator away from the wall. Setting up the refrigerator may cause
jamming noise or image chaos to the mobile phone, fixed-line telephone, radio receiver, television surrounding it, so try to
keep the refrigerator as far away as possible in such case.
IV.
Functions
1. Functions
When the refrigerator system is powered on for the first time, all icons on the display panel gets
illuminated for 2s.
1.1 Temperature setting
Temperature can be adjusted by pressing the 'SET' key. Every time when the "SET" key is pressed, the
current mode indicator lights off while the next mode indicator lights up, with the said mode setting
validated if no key operation within 5s (or else, the mode setting will be invalid). After the setting takes
effect, temperature will be immediately controlled as per the mode setting.
The temperature modes cycle as following: "5→4→3→2→1→FAST COOL→5"
COLDEST
5
4
3
2
1
COLD
The Freezing temperature control
Freezer temperature control
The freezer temperatures are controlled by the knob switch (as illustrated on
the right) in the following manner:
When the temperature mode keeps unchanged, turn the temperature control
knob switch clockwise, then the refrigerator temperature decreases while the
freezer temperature gets increased.
When the temperature mode keeps unchanged, turn the temperature control
knob switch anticlockwise, then the refrigerator temperature increases while
the freezer temperature gets decreased.
It is recommended to adjust the temperature control knob switch to the middle
position. When you need a lower freezer temperature, turn the temperature
control knob switch properly in the anticlockwise direction to decrease the
freezer temperature (note that the refrigerator temperature will increase concurrently). When the
temperature satisfies the need, be sure to turn the control knob switch back to the middle position in
a timely manner.
The fridge thermostat and the temperature control knob should be used in combination.
Use
Recommended
environment
settings
Higher
than
35℃
EN
When the user needs a colder temperature.
When in normal use.
When the user does not need a colder temperature.
Temperature adjustment
panel
mode
Recommended
positions
温度调节
knob
switch
Tips
1) It is recommended to set at
the middle mode.
2) The temperature mode can
be adjusted as recommended
in the left table in case of
change
temperature
refrigerator.
to
the
ambient
around
the