Cycle Selection Charts; Canceling A Cycle; Changing A Cycle Or Setting - Sears Kenmore ULTRA WASH 665.1774 Serie Manual De Uso Y Cuidado

Press the Cycle Select button until the light below the desired cycle is on. Repeatedly press the Options button until the desired choices
are selected. Or press START/RESUME to use the same cycle and options as in the previous cycle.
NOTE: If the last cycle you completed was a rinse cycle, the dishwasher will run the last full wash cycle and options that you selected
when you press START/RESUME.
A "●" shows the steps that are in each cycle.
Water usage is shown in U.S. gallons/liters.
These models meet the ENERGY STAR
efficiency.
Cycle time includes dry time. An asterisk ( * ) by the cycle time,
Main Wash, and Final Rinse indicates the cycle time might be
longer depending on the temperature of the water entering the
dishwasher.
1 Hr Wash
To save water and energy, High Efficiency dishwashers use
advanced filtration which may result in longer cycle times (in
some cases over 2 hours). When you need fast results, the 1 Hr
Wash will clean your dishes using slightly more water and
energy. For improved drying, select the Heated Dry option,
adding ½ hour.
Use both detergent dispenser sections.
Pre- Main Rinse
Wash Wash* or
Purge
● ● ●
Rinse
Heavy Wash
Use this cycle for heavily soiled pots, pans, casseroles, regular
tableware and hard** water conditions.
Use both detergent dispenser sections.
Pre- Main Rinse
Wash Wash* or
Purge
● ● ●
145°F Rinse
(63°C)
Normal Wash
Use this cycle for loads with normal amounts of food soil. (The
energy-usage label is based on this cycle.) During the wash
cycle, the wash action will repeatedly pause for several
seconds.
Use both detergent dispenser sections.
Pre- Main Rinse
Wash Wash* or
Purge
● ● ●
105°F Rinse
(41°C)

Cycle Selection Charts

® guidelines for energy
Final Dry Average
Rinse* Time* Usage
(min) (gal/L)
● ●
60 6.9-7.8/
Final Dry Average
Rinse* Time* Usage
(min) (gal/L)
● ●
135* 6.9-7.8/
Final Dry Average
Rinse* Time* Usage
(min) (gal/L)
● ●
115* 4.2-7.7/
135°F
(57°C)
Light Wash
Use this cycle for china and crystal. This cycle uses a light wash
and gentle dry. During the heated dry, the heating element
cycles on and off.
Use main detergent dispenser section.
Pre- Main
Wash Wash*
● ●
105°F
(41°C)
Quick Rinse
Use this rinse cycle for rinsing dishes, glasses, and silverware
that will not be washed right away.
Do not use detergent with this cycle.
Water
Wash Main
Wash
26-33
*If the incoming water temperature is less than the
recommended temperature, the cycle will automatically
compensate by adding time and heat.
**Hard water is defined as 7 grains per U.S. gallon and above.
Water
1. Press CANCEL/DRAIN. The Cancel/Drain light glows.
2. The dishwasher starts a 2-minute drain (if needed). Let the
dishwasher drain completely. The light turns off after
26-33
2 minutes. The door must be closed for the dishwasher to
drain.
To stop the drain
You can press CANCEL/DRAIN again to stop the drain. Be sure
to drain the dishwasher before starting a new cycle.
To clear the indicators
Press CANCEL/DRAIN before starting the dishwasher to clear all
Water
options and cycles.

Changing a Cycle or Setting

16-29
1. Press CANCEL/DRAIN. Your dishwasher starts a 2-minute
drain (if needed). Let the dishwasher drain completely.
2. Check the detergent dispensers. They must be filled properly
for the new cycle.
3. Make sure the door is closed.
4. Select a new cycle and/or options.
5. Press START/RESUME.
Rinse Final Dry
or Rinse*
Purge
● ● ●
Rinse 130°F
(54°C)
Rinse Final Dry
or Rinse
Purge
●
Rinse

Canceling a Cycle

Average Water
Time* Usage
(min) (gal/L)
105* 4.2-6.1/
16-23
Time Water
(min) Usage
(gal/L)
10 1.7-2.3/
6.5-8.7
13