2. Prepare the Wall
NOTE: Certain building materials can affect wireless connection to the digital valve.
Test the remote button at the desired location before installation.
NOTE: Install the product on a flat and even wall surface, avoiding grout lines, if
possible.
Once the desired location has been tested, mark the center position.
Recommended height from the floor is 58" (1473 mm).
Using a pencil and level, draw a vertical line on the center mark.
Drill a 1/4" (6 mm) hole at the center mark.
Apply silicone sealant around the hole.
Install the wall anchor.
1430529-2-B
Ø 1/4"
(6 mm)
6
Kohler Co.