Model: 2144eU
IGNITIoN INSTRUCTIoNS
1. CHECK VALVES
Turn knob to oFF position�
STEP 01
Push in knob and release� Knob should spring back�
STEP 02
If knobs do NoT
If knobs
do NoT spring back, replace valve assembly before using appliance.
spring back, replace valve assembly before using appliance.
Rotate knob to loW then turn back to oFF� Knob should
STEP 03
turn smoothly�
If burner does not ignite with open gas supply valve, gas
will continue to flow out of burner and could accidentally/
inadvertently ignite with risk of injury.
Ensure gas is o at the supply shut o valve before checking
appliance valves.
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
light burners and rotate knobs from HIGH to loW�
STEP 01
look below the cooking surface to view burners� When knob
STEP 02
is at HIGH, flames should be larger than when knob is at loW�
HEALTHY FLAME PATTERN
❶ ❶
❷ ❷
❸ ❸
❶ ❶
Flickers of yellow color.
Flickers of yellow color.
❷ ❷
dark blue color.
dark blue color.
❸ ❸
Vibrant blue.
Vibrant blue.
SUPPORT BLACKSTONE EUROPE.COM
BLACKSTONEPRODUCTS.COM/SUPPORT
3. ALWAYS CHECK BURNER FLAME BEFORE USE.
WARNING
YELLOW OR IRREGULAR
If there is a sudden drop or low
If there is a sudden drop or low
flame issue, please reference the
flame issue, please reference the
Troubleshooting chapter.
Troubleshooting chapter.
USING YOUR BLACKSTONE
2. PIEZO-ELECTRIC GRIDDLE IGNITION
do NoT lean over the appliance while lighting�
❶
❶ Push the control knob in to
start gas flowing�
1 to 3 turns
1 to 3 turns
❷ ❷ Turn the control knob
counter-clockwise to activate
the starter�
❸ ❸ Adjust the temperature to
desired level�
STEP 01
Turn gas oN by turning the gas
cylinder handwheel counter-
clockwise 1 to 3 turns�
IF IGNITION DOES NOT OCCUR IN 5 SECONDS:
Turn the burner control knob oFF�
STEP 01
Wait 5 minutes�
STEP 02
Repeat the lighting procedure�
STEP 03
If burner does not ignite, please reference the Troubleshooting chapter.
If burner does not ignite, please reference the Troubleshooting chapter.
IF IGNITION DOES NOT OCCUR IN 5 SECONDS:
| OWNER'S MANUAL
❶ ❶
❷ ❷
❸ ❸
STEP 02
❶ ❶ Push the control knob in to
start gas flowing�
❷ ❷ Turn the control knob
counter-clockwise to activate
the starter�
❸ ❸ Adjust the temperature to
desired level�
09