Publicidad
Idiomas disponibles
Idiomas disponibles
56
CONTROL PANEL
1
9
8
1. AC socket
2. DC protection reset
3. Overload indicator (red)
4. Output indicator (green)
5. Oil warning indicator (red)
POWER SWITCH
1.
Switch in position "I" OFF: The ignition circuit is disconnected. The engine doesn't work.
2.
Switch in "O" position ON: The ignition circuit is connected. The engine can run.
EARTH CONNECTION
It is used to ground the generator and avoid electrical discharges.
1.
Connect a length of heavy gauge insulated cable between the generator ground connector (on the control
panel) and a suitable ground point. You can create an earth point by nailing a metal rod to the ground and
connecting the free end of the cable to it.
OIL WARNING INDICATOR (RED)
When the oil level drops below the minimum level, the oil warning light comes on and the engine stops automatically.
Unless it's filled with oil, the engine won't start again.
OVERLOAD INDICATOR LIGHT (RED)
Lights red when the power extracted from the generator exceeds its rated power or a short circuit has occurred in a
connected device. If it remains lit, turn off the generator and disconnect one or more devices before using it again.
Make sure that the generator operates within its rated power capacity or, in the event of a short circuit of the device,
have the device repaired.
OUTPUT INDICATOR (GREEN)
It illuminates green when the generator is operating normally and the power extracted from it is within its nominal
power output capacity.
USB CHARGER
Power 5V DC or 12V DC devices that are connected through a USB cable.
2
7
6
6. Earth connection
7. DC charger output
8. Power switch
9. USB Charger
1
3
4
5
Publicidad
