Descargar Imprimir esta página

Greencut GRIC300XM Manual De Instrucciones página 61

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

MAINTENANCE
Good maintenance will extend the life of the machine. Prolonged or constant use may require more intensive
maintenance for the machine to continue to function properly.
ATTENTION: Make sure the engine is completely shut down before performing any maintenance
or repair. This will eliminate any potential risk.
PERIODIC MAINTENANCE
MAINTENANCE
Engine oil
Oil leaks
Air filter
Spark plug
Valve Adjustment
Check/tighten as
Fasteners
Fuel tank
Fuel line
Fuel filter
OIL CHECK AND OIL CHANGE
ATTENTION: The engine oil is best changed when the engine is at working temperature. Beware of
oil, as being hot can cause burns.
To check the oil:
1.
Place the machine on a flat, horizontal, unobstructed surface.
2.
Remove the 2 screws (turn counterclockwise) securing the motor access cover (A) and remove the cover.
3.
Remove the dipstick, clean it with a piece of cloth or paper, insert the dipstick, screw it on and check the
mark left by the oil. The signal left by the oil must be at the maximum permissible level.
4.
If the mark is below the minimum, add a little more oil and check again.
5.
If the oil level is too high, drain some oil until the correct level is reached.
6.
When finished, reinstall (turn clockwise) the oil fill plug until firm. Clean any oil residue from the machine.
7.
Reinstall the motor access cover and secure with the 2 screws (turn clockwise).
To change the engine oil:
1.
Place the machine on a flat, level surface and have a container ready to collect the drained oil.
2.
Remove the 2 screws (turn counterclockwise) securing the motor access cover and remove the cover.
3.
Clean the machine around the oil fill hole so that no dirt or other material enters the engine when the plug is
removed.
4.
Unscrew (turn counterclockwise) and remove the oil plug.
EVERY MONTH
EACH USE
OR 20H USE
Check
Replace
Check/repair as
necessary
Check
necessary
EVERY 3
EVERY 6
MONTHS OR
MONTHS OR
50H USE
100H USE
Replace
Clean and replace as necessary
Check
Replace
Replace if necessary
Clean and replace as necessary
61
EN
EVERY YEAR
OR 300H USE
Adjust as
necessary
Rinsing and
cleaning

Publicidad

loading