Publicidad
Idiomas disponibles
Idiomas disponibles
58
BOX CONTENTS
1.
1 Inverter Generator
2.
1 Oil dispenser
3.
1 DC load line
4.
1 Set of tools
•
Remove the product and accessories from the box. Make sure all items are present.
•
Inspect the product to ensure that it has not been broken or damaged in transit.
•
Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.
PRODUCT USE
BEFORE COMMISSIONING
FUEL
WARNINGS
•
Carefully read the section on fuel safety.
•
Use 95 unleaded gasoline.
•
Always avoid contact of gasoline or oil with your eyes. If gasoline or oil comes in contact with your eyes, flush
them immediately with clean water. If your eyes become irritated, consult a doctor immediately.
•
Do not mix oil with fuel.
•
Clean the area around the fuel cap.
•
Do not overfill the fuel tank, otherwise it may overflow when the fuel warms up and expands. In case of fuel
leakage be sure to eliminate these leaks completely before starting, move the machine away from the spill area
and avoid any source of ignition until the vapors have dissipated.
•
Separate yourself at least 3 metres from the area where you have refuelled before starting the machine.
•
Never remove the fuel tank cap while the engine is running or when the machine is hot.
•
Do not use fuels such as ethanol or methanol. These fuels will damage the engine of the machine.
FILLING THE FUEL TANK
1.
Choose a suitable area for this operation.
2.
Remove the fuel tank cap and refill with the indicated fuel.
3.
Close the fuel tank cap tightly and wipe off any fuel that may have spilled from the
outside with a dry cloth.
4.
Check if the fuel level is sufficient.
ENGINE OIL
The engine of your machine comes from the factory without oil for transport reasons. Before
starting the engine for the first time, oil must be added to the engine. This engine uses quality oil for 4-stroke engines.
FILLING THE OIL TANK
1.
Place the machine on a flat, horizontal, unobstructed surface.
2.
Loosen the screws on the side access panel to remove the cover.
Publicidad
