Sears Kenmore ULTRA WASH 665.1327 Serie Manual De Uso Y Cuidado página 101

Some state or local plumbing codes require the addition of a drain air gap between a
built-in dishwasher and the home drain system, Check the drain air gap when your
dishwasher is not draining well,
The drain air gap is usually located on top of the sink or countertop near the
dishwasher, To order a drain air gap, please call 1-800-4-MY-HOME ®, Ask for Part
Number 300096.
NOTE: The drain air gap is an external plumbing device that is not part of your
dishwasher. The warranty provided with your dishwasher does not cover service costs
directly associated with the cleaning or repair of the external drain air gap.
To clean the drain air gap
Clean the drain air gap periodically to ensure proper drainage of your dishwasher.
With most types, you lift off the chrome cover. Unscrew the plastic cap. Then check
for any soil buildup. Clean if necessary.
To reduce the risk of property damage • If you will not be using the dishwasher during the summer months, turn off the
water and power supply to the dishwasher.
• Make sure the water supply lines are protected against freezing conditions. Ice
formations in the supply lines can increase water pressure and damage your
dishwasher or home. Damage from freezing is not covered by the warranty.
• When storing your dishwasher in the winter, avoid water damage by having your
dishwasher winterized by authorized service personnel.
TROUBLESHOOTING
CHECK THESE POINTS TO HELP SAVE YOU TIME AND MONEY.
PROBLEM SOLUTION ..................................
DISHWASHER DOES NOT RUN
DETERGENT REMAINS IN THE
DISPENSER OR TABLET IS ON
BOTTOM OF TUB
NOTE: It is normal for the dishwasher to repeatedly pause several times during a cycle.
If the Start light is blinking, close the door and push START.
Be sure the door is closed and latched.
Check that there is not an interference with large casserole dishes and the wash system at the
back of the dishwasher. Adjust loading as necessary to ensure door is closed and latched.
Be sure you have selected a cycle. (See "Cycles and Options Information.")
Be sure there is power to the dishwasher. A circuit breaker or fuse may have tripped.
If lights other than Start blink and the unit will not run, you will need to call for service.
Check for dishware such as cookie sheets, cutting boards, or large containers, etc., that may be
blocking the detergent dispenser from opening properly.
Be sure your detergent is fresh and lump free.
Be sure the cycle has completed (blue light is on). If it has not completed, you will need to resume
the cycle by closing the door and pressing START.
21