Publicidad
Idiomas disponibles
Idiomas disponibles
9.2. CLEANING THE SPRAY ARMS
EN
It is necessary to clean the spray arms regularly for
hard water chemicals will clog the spray arm jets
and bearings.
1.
To remove the spray arms, unscrew the nut
clockwise to take out the washer on top of the
spray arm and remove the arm.
2.
Wash the arms in soapy and warm water and
use a soft brush to clean the jets.
3.
Replace them after rinsing thoroughly.
9.3. CARING FOR THE DISHWASHER
To clean the control panel, use a slightly damp cloth
then dry thoroughly.
To clean the exterior, use a good appliance polish
wax. Never use sharp objects, scouring pads or
harsh cleaners on any part of the dishwasher.
9.4. CLEANING THE DOOR
To clean the edge around the door, you should use only a soft, damp cloth. To prevent
water from entering the door lock and electrical components, do not use a spray
cleaner of any kind.
Never use abrasive cleaners or scouring pads on the outer surfaces because they will
scratch the finish. Some papers towels can also scratch or leave marks on the surface.
Follow these steps when there is foreign material in the dishwasher.
WARNING
Never use a spray cleaner to clean the door panel for it could damage the door lock
and electrical components. It is not allowed to use the abrasive agent or some paper
towel because of the risk of scratching or leaving spots on the stainless steel surface.
9.5. HOW TO KEEP YOUR DISHWASHER IN GOOD CONDITION
Frost precaution
If your dishwasher is left in an unheated place during the winter, ask a service technical
to:
1.
Cut off electrical power to the dishwasher.
2.
Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.
Drain water from the inlet pipe and water valve. (Use a pan to gather the water)
4.
Reconnect the water inlet pipe to the water valve.
5.
Remove the filter in the tub and the bottom and use a sponge to soak up water in
sump.
After every wash
After every wash, turn off the water supply to the appliance and leave the door slightly
ajar so that moisture and odors are not trapped inside.
Remove the plug
Before cleaning or performing maintenance, always remove the plug from the socket.
Do not run risks.
No solvents or abrasive cleaning
To clean the exterior and rubber parts of the dishwasher, do not use solvents or
abrasive cleaning products. Use only a cloth and warm soapy water. To remove spots
or stains from the surface of the interior, use a cloth dampened with water and a little
22
Publicidad
