Reolink Duo 2 LTE Instrucciones Operativas página 12

• Make sure the PIR schedule is set up
properly.
• Check the network connection on your
phone and try again.
• Make sure the camera is connected to the
Internet. If the LED indicator under the
camera daylight sensor is solid red or
flickering red, it means that your device
disconnects from the Internet.
• Make sure you've enabled Allow
Notifications on your phone. Go to the
System Settings on your phone and allow
Reolink App to send push notifications.
If these won't work, please contact Reolink
Support https://support.reolink.com
Specifications
PIR Detection & Alerts
PIR Detection Distance:
Adjustable/up to 10m (33ft)
21 English
PIR Detecting Angle: 150° horizontal
Audio Alert:
Customized voice-recordable alerts
Other Alerts:
Instant email alerts and push notifications
General
Operating Temperature:
-10°C to 55°C (14°F to 131°F)
Size: 81x103x195mm
Weight (Battery included): 720g (17.1 oz)
Notification of
Compliance
FCC Compliance Statement
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this
device must accept any interference
received, including interference that may
cause undesired operation. Changes or
modifications not expressly approved by
the party responsible for compliance could
void the user's authority to operate the
equipment.
NOTE: This equipment has been tested
and found to comply with the limits for
a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits
are designed to provide reasonable
protection against harmful interference in
aresidential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions,
may cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur
in a particular installation.If this equipment
does cause harmful interference to radio
or television reception, which can be
determined by turning the equipment off
and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
FCC RF warning statement:
The device has been evaluated to meet
general RF exposure requirement. The
device can be used in portable exposure
condition without restriction.
English 22