Craftsman 917.28948 Manual Del Operador página 10

4. Slide mower under tractor,
o Bring belt forward and check belt for
proper routing in all mower pulley grooves.
NOTE: Be sure mower side suspension
arms (A) are pointing forward before sliding
mower under tractor.
° Slide mower under tractor until it is
centered under tractor.
5. Install anti-sway bar (S) (If equipped)
Anti-Sway Bar (S)
_d'Towards Towards
Mower Deck -F-
_-"k_ Transaxle :
90 ° End Integrated Washer End
• From right side of mower, first insert
90 ° end of anti-sway bar (S) into hole in
transaxle bracket (T), located near left
rear tire in front of transaxleo
NOTE: Flashlight may be helpful.
s_
Bar f l ./_-_'_ ...................
f ":
(S) i' ........ . _,
>_ .......... T, ,
c ,,z ";,-_,71'
t. ",_
_CJI
Transaxle Bracket (T)
Located Between Rear Tires
• Pivot the integrated washer end of anti.,
sway bar (S) towards mower deck bracket
on right side of mower. Insert integrated
washer end of bar into hole in rear mower
bracket (D). Move mower as needed to
insert integrated washer end of bar into
rear mower bracket (D).
° Secure with small washer and small
retainer spring as shown.
Do Right Side Rear
Mower Bracket
S. Anti-Sway Bar
T Transaxle Bracket
Attach mower side suspension arms
(A) to chassis,
. Position front hole in side suspension arm
(A) over pin on outside of tractor chassis
and secure with large washer and large
retainer spring (B).
• Repeat on opposite side of tractor.
A. Mower Side Suspension Arms
B. Retainer Spring
D. Right Side Rear Mower Bracket
1". Transaxle Bracket
NOTE: Depending on model, bracket (T) may
be differentthan shown but hole for anti-sway
bar wilt be in same position/location.
7. Attach rear lift links (C)
• Insert rod end of rear lift link (C) into hole
(U) in tractor lift shaft suspension arm
and pivot link down to mower°
° Lift rear cornerof mower and position slot
in link assembly over pin on rear mower
bracket (D) and secure with large washer
and large retainer spring.
• Repeat on opposite side of tractor,
10