Publicidad
Idiomas disponibles
Idiomas disponibles
REPLACING
BATTERY
,_WARNING:
Do not short batteryterminals
by allowing
a wrench or any other object to
contact
both terminals
at the same time.
Before
connecting
battery,
remove
metal
bracelets,
wristwatch
bands,
rings,
etc.
Positive
terminal
must be connected
first to
prevent sparking from accidental
grounding.
1.
2.
3,
4_
5_
6_
Lift hood to raised position.
Disconnect
BLACK battery cable (A) then
RED battery cable and carefully
remove
battery from tractor.
install new battery with terminals
in same
position
as old battery.
First connect
RED battery
cable
(B) to
positive
(+) battery terminalwith
hex bolt
and keps nut as shown. Tighten securely.
Slide terminal
cover (C) over terminal.
Connect
BLACK grounding cable to neg-
ative (-) battery terminal
with remaining
hex bolt and keps nut, Tighten
securely.
Close hood.
_. _ Negative
(Black)
Cable
Positive
(Red)
Cable
TO REPLACE HEADLIGHT BULB
1. Raise hood.
2. Remove bulb holder from the hole in the
backside of the grill.
3. Replace bulb in holder and install bulb
holder securely back intothe hole in the
backside of the grill,
4. Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your
tractor to run poorly,stop running,orprevent
it from starting.
• Check wiring.
TO REPLACE FUSE
Replace with30 amp automotive-type plug-
in fuse. The fuse holder is located behind
the dash.
TO REMOVE
HOOD AND GRILL
ASSEMBLY
!.
Raise hood.
2.
Unsnap
headlight
wire connector.
3.
Stand in front of tractor. Grasp hood at
sides,
tilt toward engine and lift off of
tractor.
4.
When replacing hood, be sureto reconnect
the headlight
wire connector.
Hood
Headlight Wire
Connector
TRANSMISSION
REMOVAL/REPLACE-
MENT
Should your transmission
require
removal
for service
or replacement,
it should
be
purged after reinstatlation
and before
op-
erating the tractor.
See "PURGE
TRANS-
MISSION"
in the Operation
section
of this
manual.
ENGINE
TO
ADJUST
THROTTLE
CONTROL
CABLE
The
throttle
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary
Check adjustment
as described
below before loosening
cable. If adjustment
is necessary,
see engine manual.
TO ADJUST
CHOKE
CONTROL
The
choke
control
has
been
preset
at
the factory
and adjustment
should
not be
necessary.
If adjustment
is necessary,
see
engine manual.
TO ADJUST
CARBURETOR
Your carburetor has been preset at the factory
and adjustment
should
not be necessary.
However, minor adjustment
may be required
to compensate
for differences
in fuel, tem-
perature,
altitude or load. If the engine does
need adjustment,
see engine
manual.
3O
Publicidad
