Publicidad
Idiomas disponibles
Idiomas disponibles
TO MOVE FORWARD AND BACKWARD
The direction and speed of movement is
controlled by the forward and reverse drive
pedals.
1. Start tractor and release
parking
brake.
2. Slowly depress forward(K) or reverse(L)
drive pedal to begin movement° Ground
speed increases the further down the
pedal is depressed.
TO USE CRUISE CONTROL
The cruise control feature can be used for
forward travel only.
SYSTEM CHARACTERISTICS
The cruise control should only be used
while mowing or transporting on relatively
smooth, straight surfaces. Other conditions
such as trimming at slow speeds may cause
the cruise control to disengage. Do not use
the cruise control on slopes, rough terrian
or while trimmimg or turning.
° With forward drive pedal depressed to
desired speed, pull cruise control lever
(J) up and hold while lifting your foot off
the pedal, then release the lever.
To disengage the cruise control, depress the
brake pedal, tap on forward drive pedal or
push the cruise control lever down.
TO ADJUST MOWER CUTTING HEIGHT
The position of the attachment lift lever (A)
determines the cutting height.
, Put attachment liftlever in desired cutting
height slot.
• Slide pointer tab (1") to desired cutting
heightas a reminder for next timeyou mow.
The cutting
height
range is approximately
1" to 4". The heights are measured
from the
ground to the blade tip with the engine not run-
ning. These heights are approximate
and may
vary depending
upon soil conditions,
height
of grass and types of grass being mowed.
, The average
lawn should
be cut to ap-
proximately
2-1/2" during the cool season
and to over 3" during
hot months.
For
healthier
and better looking
lawns,
mow
often and after moderate
growth.
° For best cutting
performance,
grass over
6" in height should be mowed twice. Make
the first cut relatively
high; the second to
desired
height
TO ADJUST
GAUGE
WHEELS
Gauge wheels
are properly
adjusted
when
they are slightly off the ground when mower
is at the desired
cutting
height in operating
position.
Gauge wheels
then keep the deck
in proper
position
to help prevent
scalping
in most terrain
conditions°
NOTE: Adjust gauge wheels with tractor
on
a flat level surface°
1. Adjust
mower to desired
cutting
height
(See "TO ADJUST
MOWER
CUTTING
HEIGHT'
in this section
of manual).
2. With mower in desired height of cut posi-
tion, gauge wheels should be assembled
so they are slightly offthe
ground.
Install
gauge wheel in appropriate
hole. Tighten
securely.
3.
Repeat for all, installing
gauge wheel in
same adjustment
hole.
TO OPERATE MOWER
Your tractor is equipped with an operator
presence sensing switch. Any attempt by the
operator to leave the seat with the engine
running and the attachment clutch engaged
will shut off the engine. You must remain
fully and centrally positioned in the seat to
prevent the engine from hesitating or cutting
offwhen operating your equipment on rough,
rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
16
Publicidad
