Publicidad
Idiomas disponibles
Idiomas disponibles
AIR FILTER
Your engine
will not run properly
using
a
dirty air filter. Service
paper cartridge
every
two months or every 25 hours of operation,
whichever
occurs first.
Service
paper cartridge
more often
under
dusty conditions_
Replace the paper cartridge annually, or after
every 100 hours of operation.
TO SERVICE
CARTRIDGE
° Replace
a dirty, bent, or damaged
car-
tridge. Handle new cartridge
carefully;
do
not use if the rubber seal is damaged.
NOTE:
Do not wash
the paper
cartridge
or use pressurized
air, as this will damage
the cartridge.
1o Open door (A) on the blower
housing
lo
access the air cleaner
element
(B).
2. Unhook the latch (C) and remove the
element.
3.
Gently tap the paper element to dislodge
dirt.
4.
Clean all air cleaner components
of any
accumulated
dirt
or foreign
material.
Prevent any dirt from entering
the throat
of carburetor.
5.
Install
cleaned
or new element
on the
base and secure with latch.
6.
Close and latch the door.
CLEAN
AIR SCREEN
Air screen must be kept free of dirt and chaff
to prevent engine damage from overheating,
Clean with a wire brush or compressed
air to
remove dirt and stubborn
dried gum fibers.
CLEAN
AIR INTAKE/COOLING
AREAS
To ensure proper
cooling, make
sure the
grass screen,
cooling fins, and other exter-
nal surfaces
of the engine
are kept clean
at at! times.
Every
100 hours
of operation
(more
often
under
extremely
dusty', dirty
conditions),
remove the blower housing and other cooling
shrouds.
Clean the cooling fins and external
surfaces as necessary.
Make sure the cooling
shrouds
are reinstalled.
NOTE:
Operating the enginewith
a blocked
grass screen,
dirty or plugged
cooling fins,
and/or cooling
shrouds
removed
will cause
engine damage
due to overheating.
MUFFLER
Inspect
and replace
corroded
muffler
and
spark arrester (if equipped)
as it could create
a fire hazard
and/or
damage.
SPARK
PLUG(S)
Replace
spark plug(s)
at the beginning
of
each
mowing
season
or after
every
t00
hours of operation,
whichever
occurs
first.
Spark plug type and gap setting are shown
in "PRODUCT
SPECIFICATIONS"
section
of this manual.
IN-LINE FUEL FILTER
The fuel filter should be replaced once each
season,
If fuel filter becomes clogged, ob-
structing fuel flow tocarburetor, replacement
is required.
1. With engine cool, remove filter and plug
fuel line sections_
2, Place new fuel filter in position infuel line
with arrow pointing towards carburetor.
3, Be sure there are no fuel line leaks and
clamps are properly positioned°
4, lmmediatelywipe up anyspitled gasoline,
Clam_mp
Fuel Filter
24
Publicidad
