Publicidad
Idiomas disponibles
Idiomas disponibles
11. PLACING THE GREASE BUCKET
Parts Required:
1
x
Grease Bucket (#28)
Installation:
•
Place the grease bucket on the spout hook on the end of the main
barrel. Ensure it is level to avoid grease spills.
12. INSTALLING THE SPICE BOX, BOTTLE OPENER
Parts Required:
1
x
Spice Box (#9)
1
x
Bottle Opener (#8)
Installation:
•
Remove the top two screws on the side of the Hopper, below the hopper
handle. Align and place the Spice Box onto the bottom two screws, push
down into place, then re-install the top two screws to secure the Spice
Box onto the Hopper.
•
Remove the two pre-mounted screws for the Bottle Opener on the side
of the Hopper, above the hopper handle. Install the Bottle Opener in the
same location using the two screws previously removed. The unit is now
completely assembled.
13. CONNECTING TO A POWER SOURCE
NOTE: Before plugging your Pit Boss® into any electrical outlet, ensure
the temperature dial is in the OFF position.
STANDARD OUTLET
•
This appliance requires 110-120 volt, 60Hz, 275w service. It must be a
3-prong grounded plug. Ensure grounded end is not broken off before
use. The control uses a 110-120 volt, fast-blow fuse to protect the board
from the igniter.
GFCI OUTLETS
•
This appliance will work on most GFCI outlets, with a recommended
size of 15 amp service. If your GFCI outlet is highly sensitive to power
surges, it will likely trip during the start-up phase of operation. During
the start-up phase, the igniter draws 200-700 watts of electricity, which
can be too much power for a GFCI outlet to handle. Each time it trips, it
increases in sensitivity. If the GFCI keeps tripping, replace the outlet or
change to a non-GFCI outlet.
IMPORTANT: Disconnect unit from power source when not in use.
Refer to Owner's Manual for Operating Instructions.
10
11
28
12
8
9
13
FAST-BLOW FUSE
Publicidad
