If any anomalies are detected,
consult the following table:
ANOMALIES
Water comes out of the
holes on the bottom of the
iron when the steam button
is pressed (G).
Scale and impurities come
out of the soleplate
Steam comes out of the
cleaning stopper (K) of the
detachable water heater.
Steam does not come out
when the vapour button (G)
is pressed.
When the detachable
water heater switch is
connected, small noises in
the appliance interior can
be heard.
CAUSES
Iron temperature regulator
positioned at minimum
"·" "··"
Detachable water heater
too full.
Detachable water heater in
slanting position.
Excessive accumulation
of lime scale in the
detachable water heater.
Cleaning stopper
incorrectly screwed in.
Detachable water heater
empty.
Switches (B) and (A) are
turned off.
Residual steam is left over
from the last time the iron
was used.
The appliance is cold
(noises come from the
appliance dilation).
The detachable water
heater is empty and needs
to be filled with water
SOLUTIONS
Turn the thermostat control
until situated in the steam
zone "...".
Remove water.
Place the appliance on a
horizontal base.
Clean the appliance. See
"cleaning" section.
Let the detachable water
heater down and completely
screw in the stopper K until.
Clean the deposit J (See
section "how to keep the
appliance clean and free of
lime-scale)
Turn the switches so that
they are connected.
Press the steam button
(G) so that the pressure
evaporates.
This phenomenon is normal
and it will disappear in
some minutes.
It's natural and disappears
when it is refilled with
water.