Publicidad
Idiomas disponibles
Idiomas disponibles
Smart dosing: Get the right grind without the guesswork. Smart dosing technology eases
preparation by producing the ideal volume and consistency for 1 or 2 Shots of Espresso at the
push of a button.
Manual dosing: Personalize your Espresso by manually dosing the exact amount of grounds
you want. With the Portafilter in the grinding cradle, hold down the
Grind Start/Stop Button (
NOTE: Manual grinding will stop after 3 minutes to avoid overheating. The
Semi-Automatic Espresso Machine is not intended for continuous non-stop grinding.
ADJUSTING TOP BURR
For additional grind size personalization, the Top Burr can be adjusted to reach 8 additional
finer grind sizes.
1.
Remove the Bean Hopper lid, rotate the knob and lift the Bean Hopper to remove. Empty
beans into another container by aligning Bean Hopper over container and rotating the
knob again.
2.
Replace the empty Bean Hopper and rotate the knob to lock into place. Press the
Grind Start/Stop Button (
3.
Unplug the Semi-Automatic Espresso Machine. Remove the Bean Hopper and discard of
any remaining coffee beans in the machine. Lift the Wire Handle of the Top Burr. Twist to
unlock and lift the Top Burr by using the Wire Handle.
TIP: Use the Brush found in the Accessory Storage Tray to clean, underneath the
Bean Hopper and around the Top Burr.
4.
Lift the Top Burr micro adjustment latch. Then, rotate the Top Burr to desired setting and
engage adjustment latch back into position.
5.
Return the Top Burr to the machine and twist to lock into position. Reattach the
Bean Hopper.
BREWING EXTRACTION GUIDE
1.
Position the Portafilter under the Group Head with the handle align to unlock. Raise the
Portafilter into the Group Head and twist to the right side to lock.
2.
Toggle the Mode Button to select Espresso mode. Toggle the Dose Button to select
desired number of Shots 1 (~ 1 oz/~ 29.5 ml) or 2 (~ 2 oz/~ 59 ml).
3.
Toggle the Temperature Button to select desire extraction temperature. Press the
Brew Start/Stop Button (
NOTE: Do not remove the Portafilter when brewing.
Personalize Brew
Temperature: Utilize the easily selectable temperature settings to adjust the Espresso
temperature to your taste.
■
Low
■
Medium
■
High
To change pre-programmed Espresso volume for 1 or 2: Toggle the Mode Button to select
Espresso mode. Select the dose you desire to program (1 or 2). Press and hold
Brew Start/Stop Button (
programing your selected dose, the dose and the Brew Start/Stop Button (
blink. Lights will stop blinking when programming is complete.
TIP: To restore all factory settings, press and hold Dose Button for 3 seconds. All indicator
lights will blink indicating that all settings are restored.
) until it reaches your ideal amount of grounds, then release.
) to run the grinder until empty.
) to run selected Espresso cycle.
) until the desired Espresso amount is reached in your cup. While
) lights will
9
Publicidad
