Prior To Use; Installation - LIVARNO LUX LSLB 10 A1 Manual De Instrucciones

LIVARNO LUX LSLB 10 A1

6. Prior to use

Remove the LED spotlight and the installation materials from the packaging.
Check the LED spotlight for signs of damage. If damaged, the LED spotlight
must not be used.

6.1. Installation

The installation must be performed only by
an authorised electrician!
The circuit must be switched off during the
installation!
Use suitable tools for the installation.
When drilling the holes, make sure that no
cables or pipes in the wall are damaged.
Use a H05RN-F power cable (12), for
example.
 Remove the mounting bracket (3) from the LED spotlight. To do so, remove
the screws (2) and the corresponding spring washers and flat washers on
the left and right of the mounting bracket (3).
 Use the mounting bracket (3) as a template to mark the two outer holes.
 Then drill two holes and attach the mounting bracket (3) using the
supplied installation materials (2 plugs and 2 screws).
 Open the junction box (11) by loosening the four screws at the corners of
the box and removing the cover.
 Loosen the cable gland (10) and remove the rubber seal.
 Put the nut of the cable gland (10) and then the rubber seal with the flat
side first on the power cable (12).
 Run the power cable (12) through the cable bushing (9).
 Connect the power cable (12) using the screw terminal (13). Make sure
that the individual wires of the power cable (12) are connected correctly.
Wire
Black or brown
Blue
Yellow/green
 Now screw the power cable (12) with the rubber seal into the cable
bushing (9) by tightening the nut of the cable gland (10) again.
18 - English
Symbol
L
N
Designation
Phase
Neutral
Earth conductor