Adjusting Light Sensitivity (Lux); Maintenance / Cleaning; Maintenance; Cleaning - LIVARNO LUX LSLB 10 A1 Manual De Instrucciones

LIVARNO LUX LSLB 10 A1

7.4. Adjusting light sensitivity (LUX)

You use the LUX control (5) at the bottom of the motion sensor (4) to adjust
the light sensitivity. Here, you set the lighting conditions to which the twilight
sensor is to respond and thus switch on or off the LED spotlight.
Turn the LUX control (5) clockwise (
(4) responds to brighter lighting conditions.
Turn the LUX control (5) anti-clockwise (
sensor (4) responds to darker lighting conditions.

8. Maintenance / cleaning

8.1. Maintenance

The light bulb of the LED spotlight is a long-lasting LED. It cannot be
replaced and does not require maintenance.
The light source of this light cannot be replaced; when the light source has
reached the end of its service life, the entire light must be replaced.

8.2. Cleaning

Ensure that no liquid can penetrate the
housing. There is a risk of an electric shock.
To clean the LED spotlight, use a soft, dry cloth and never use any solvent or
cleaner that would corrode the plastic materials. Use a slightly damp cloth
for more stubborn dirt.

9. Troubleshooting

The light does not switch itself on
 The motion sensor (4) is not aligned correctly. Correct the alignment.
 The electrical connection is faulty. Get an authorised electrician to check
the electrical connection.
The light switches on and off quickly
 The sensor is disturbed by extraneous light or bright reflective surfaces.
Remove the extraneous light source or the disturbing surfaces.
The light does not switch off
 Persons or objects are within the detection range of the motion sensor (4).
Remove them.
 The LED spotlight moves in the wind, which continually triggers the motion
sensor (4). Attach the LED spotlight only to a stable installation location.
20 - English

direction) so that the motion sensor

direction) so that the motion