Publicidad
Idiomas disponibles
Idiomas disponibles
6.3.3 Table of error messages with the Memory
control panel
Signal/Code
C01
C02
C11
C12
C15
SP
For more error messages, see the detailed user guide at steelcase.com/eu-en
Message
Motor 1 short circuit
Motor 2 short circuit
Cable from motor 1
was disconnected
Cable from motor 2
was disconnected
No pulses can be
measured
System protection /
system pause
The controller
monitors the switch-
on time (time-
controlled) and its
maximum
temperature. One of
the two values was
exceeded.
6 Errors and faults
Required measure(s)
Unplug the mains plug!
Rectify the short circuit,
Check the cables to the
motors for possible damage
or insert the correct motor
into the socket in question.
Restart the controller.
Perform reference run, if
necessary.
Check cable or plug-in
connection to the motors
and perform reference run.
Unplug the mains plug!
Rectify the external short
circuit, check the cables to
the motors for possible
damage or insert
the correct motor into the
socket in question. Restart
the controller. Perform
reference run, if necessary.
Wait until the controller has
cooled down and the SP
display goes out. Then a
movement duration of 20s is
enabled again.
Only after 18 minutes will
the table move again for 2
full minutes.
ATTENTION! The switch-on
time is calculated even if no
mains voltage is applied.
EN
37
Publicidad
