Publicidad
Idiomas disponibles
Idiomas disponibles
Advance Planning
DUCTWORK PLANNING FOR VENTED
MODE
¢ This vent hood is designed to be installed beneath a
cabinet or beneath a cabinet mounted to a soffit.
¢ This hood is designed for 8" round ducting. The
8" round duct can transition to 3-1/4" x 10" or
3-1/4" x 12".
e Plan the route for venting exhaust to the outdoors
considering any transitions you may require.
¢ Use locally supplied ducting to vent horizontally
through the rear wall or vertically through the
ceiling.
e Use the shortest and straightest duct route
possible. For satisfactory performance, duct run
should not exceed 100' equivalent length for any
duct configurations.
¢ Refer to "Duct Fittings" chart to compute the
maximum permissible length for duct runs to
the outdoors.
e Install a wall or roof cap with damper at the exte-
rior opening. Order the wall or roof cap and any
transition and length of duct needed in advance
from a local hardware store.
¢ Determine the exact location of the vent hood.
¢ Wall or ceiling duct must be projected out at least
1" for duct connection.
A WARNING:
TO REDUCE THE RISK OF
FIRE, USE ONLY METAL DUCTWORK.
¢ For better air flow results, use rigid metal ductwork.
DUCTWORK PLANNING FOR
RECIRCULATION MODE
All parts are included to install in recirculation mode.
MOUNTING FOR ADEQUATE SUPPORT
¢ The hood must be secured to vertical studs in the
wall. See the Wall or Ceiling and Cabinet Preparation
section for vented or recirculationg installation.
e We strongly recommend that the vent hood be on
-site to accurately locate the ductwork and electri-
cal service.
¢ Installation will be easier if the vent hood is in-
Stalled before the cooktop and countertop are
installed.
IMPORTANT: The vent hood must be secured
to the cabinet and at least two wall studs and
dry wall with anchors. The cabinet must be ca-
pable of supporting 100 Ibs.
Publicidad
