Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions
INSTALLATION - VENTED TO THE OUTSIDE
[ 1 |DUCTWORK, WIRING LOCATIONS
Determine the exact location of the vent hood.
¢ Locate the template packed with the literature.
- Measure 36" from the floor to the top of the cook-
ing surface. Add hood installation height deter-
mined on previous pages. Mark that location.
- Use a level to draw a straight pencil line on the wall.
- Tape the template in position along the penciled
line. CHECK TO BE SURE THE TEMPLATE IS LEVEL.
65/8"
t
8-1/2" diam.
Cabinet/Ceiling ducting:
If ductwork will vent straight up to the ceiling or
cabinet:
e Use a level to draw a line straight up, from the cen-
terline on the template to the ceiling/cabinet.
e Measure 6-5/8" from the back wall to the centerline
of an 8-1/2" hole on the ceiling/cabinet top.
NOTE: If drywall is not present, add drywall thickness
to the 6-5/8" dimension.
Wall Ducting:
If ductwork will vent to the rear:
e Use a level to draw a line straight up from the
centerline on the template.
* Measure at least 8 1/4" above the hood chassis
top surface location shown on the template to the
centerline of a 8-1/2"-dia. duct hole. (Hole may be
elongated for duct elbow.)
House Wiring Location:
¢ The junction box is located on the top right side of
the hood.
[1 |pucTWoRK,
WIRING
LOCATIONS
(Continued)
¢ Wiring can enter the cabinet from the ceiling or
back wall.
¢ Route additional wiring length to reach the junction box.
[2 ]WALL OR CEILING AND CABINET
PREPARATION
IMPORTANT —The vent hood must be secured
to the cabinet and at least two wail studs and
drywall with anchors. Cabinet must be capable of
supporting 100 Ibs.
e With the template taped in place, use a punch to
mark all mounting screw locations. Mark duc-
twork, screw and electrical holes according to
your application.
¢ Drill a minimum 3/4" hole for electrical cable in
the bottom of the cabinet.
* Drill 1/8" pilot holes at the 4 punched locations on
the bottom of the cabinet.
* Drill 1/8" pilot holes at the 4 punched locations on
the wall
e Remove the template.
* Enlarge holes that did not enter studs to 5/16".
Tap anchors for wall fasteners into the holes.
Cabinet mounting
screw locations
Cabinet template
Wall mounting
screw locations
a
NOTE: It is important to engage the wall
studs with at least two screws. Use the
holes which align with the studs.
Wall template
10
Publicidad
